Zelmer BM1000(Часть 2) - Инструкция по эксплуатации - Страница 138

144

QUESTIONS AND ANSWERS CONCERNING THE APPLIANCE

PROBLEM

CAUSE

SOLUTION

Smoke comes out of the baking 

compartment or the vents.

The ingredients stuck to the 

baking compartment or to the 

outside of the baking tin.

Unplug the appliance and clean the outside of the baking tin or the 

baking compartment.

The bread goes down in the 

middle and is moist on the 

bottom.

The bread was left for too long 

in the baking tin after baking 

and warming.

Take the bread out off the baking tin before the end of the warming 

function.

It is dificult to take the bread 

out of the baking tin.

The bottom of the total is stuck 

to the kneading peg.

Clean the kneading peg and shaft before the next time you bake 

bread. If necessary, ill the container with warm water and leave for 

30 minutes. This way the kneading pegs can be easily removed and 

cleaned.

The ingredients are not mixed 

or the bread is not baked 

properly.

Incorrect program setting.

Check the selected menu and other settings.

The START/STOP button was 

pressed while the machine was 

working.

Do not use the ingredients and start the whole process again.

The lid opened several times 

while the machine was working.

The lid can only be opened if the time left on the display is more than 

1:30 (this concerns only programs 1,2,3,4)

Make sure the lid was closed properly.

Long blackout while the 

machine was working.

Do not use the ingredients and start the whole process again.

The rotation of the kneading 

pegs is blocked.

Check if the kneading pegs are not blocked by for example grains, etc. 

Pull out the baking tin and check if the drivers turn. If this is not the 

case, return the appliance to a service point.

The appliance does not start. 

The audible signal goes off. The 

display shows the symbol E 01.

The appliance is still hot after 

the previous baking process.

Press and hold the START/STOP button until the normal program code 

appears on the display. Unplug the appliance. Take out the baking 

tin and leave to cool at room temperature. Plug in and restart the 

appliance.

The display shows the symbol 

“EEE”.

Program or electronic error.

Start the test run. Press and hold the menu button, unplug the 

appliance and then plug it in again. Release the button. The appliance 

will perform a test run. Unplug the appliance again. The normal 

program code should appear on the display. If this is not the case, 

return the appliance to a service point.

Wipe the outside of the baking tin with a damp cloth. The 

●

inside of the tin can be washed with dishwashing liquid. 

Do not immerse the tin into water. 

Clean the kneading pegs and the drive shaft immediately 

●

after  use.  If  the  kneading  pegs  remain  in  the  tin,  it  will 

be dificult to remove them afterwards. In such a case ill 

the container with warm water and leave for 30 minutes. 

Next remove the kneading pegs. 

The  baking  tin  has  a  non-stick  coating.  Do  not  use 

●

metal  objects  that  could  scratch  the  coating.  The  color 

of the coating will change during the course of use. This 

is  a  normal  situation.  This  change  does  not  affect  the 

effectiveness of the coating in any way. 

Make  sure  the  appliance  has  completely  cooled  down 

●

and  is  dry  before  storing.  Store  the  appliance  with  the 

lid closed.

GW43-013_v02