Bosch PPS 7 S - Инструкция по эксплуатации - Страница 49

 English | 

49

Bosch Power Tools

1 609 929 W71 | (30.3.11)

Starting Operation

f

Observe correct mains voltage! The voltage 
of the power source must agree with the 
voltage specified on the nameplate of the 
machine. Power tools marked with 230 V 
can also be operated with 220 V.

Starting and Stopping

–

To start

 the operation, press the green ON 

button 

16

.

–

To stop

 the operation, press the red OFF but-

ton 

17

.

Power Failure

The ON/OFF switch is a so-called non-voltage 
switch, which prevents the power tool from re-
starting after a power failure (e. g., when the 
mains plug is pulled during operation).
To restart the operation of the machine after-
wards, the green ON button 

16

 must be pressed 

again.

Working Advice

General Sawing Instructions

f

For all cuts, firstly ensure that the saw 
blade cannot touch or graze against the 
stops (guide rail 31 or fence 36 of the uni-
versal guide) or any other machine parts.

f

Use the machine for grooving or rebating 
only with an appropriately suitable protec-
tive device (e. g. a tunnel blade guard).

f

Do not use the machine for cutting slots 
(stopped grooves).

Protect the saw blade against impact and shock. 
Do not subject the saw blade to lateral pressure.
The riving knife must be in alignment with the 
saw blade to avoid jamming of the workpiece.
Do not work bent or warped workpieces. The 
workpiece must always have a straight edge to 
place it flush against the universal guide.
Always keep/store the push stick with the pow-
er tool.

Position of the Operator (see figure P)

f

Do not stand in a line with the saw blade in 
front of the machine. Always stand aside of 
the saw blade. 

This protects your body 

against possible kickback.

– Keep hands, fingers and arms away from the 

rotating saw blade.

Observe the following instructions:
– When sawing narrow workpieces and bevel 

angles, always use the supplied push stick 

12

and the universal guide 

1

.

– Operation as a Pull Push Saw:

Hold the workpiece and press it firmly 
against the fence.

– Operation as a Table Saw:

Hold the workpiece securely with both hands 
and press it firmly against the saw table.

Maximum Workpiece Dimensions

Operation as a Pull Push Saw

Operation as a Table Saw

Sawing

Operation as a Pull Push Saw

When sawing with sliding action, you pull the 
saw blade from rear to front through the held 
workpiece.
This operating mode is suitable for:
– Precise  cuts
– Separating cuts

Workpiece height

Cutting length (max.)

20 mm

212 mm

40 mm

199 mm

60 mm

168 mm

Bevel angle

Workpiece height 

(max.)

0 °

62 mm

45 °

36 mm

OBJ_BUCH-1259-002.book  Page 49  Wednesday, March 30, 2011  11:02 AM