Мойки высокого давления Karcher CB 1 25 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
English
29
100
Wheel wash brush 1 facing outwards (during the wash)
Interference in
compressed air
supply, limit
switch distort-
ed.
Check com-
pressed air
supply, check
limit switch.
101
Wheel wash brush 2 facing outwards (during the wash)
102
Roof brush performance limit 4 too long exceeded
Failure in the
control.
Drive vehicle
out of the plant,
switch off main
switch, wait for
10 seconds,
switch on main
switch again,
press Reset
button, press
button Normal
setting, repeat
washing proce-
dure.
103
Side brush 1 performance limit 4 too long exceeded
104
Side brush 2 performance limit 4 too long exceeded
105
Exceeding maximum wash section time
106
Exceeding maximum portal shutdown time
120
Portal blocked
Light barrier
dirty/defective
Clean light bar-
riers.
122
Switch strip/bow Roof drier
Vehicle too
high, fault in the
Control
Drive too high a
vehicle out of
the plant, re-
start plant.
130
Vehicle has come out of the wheel trough (during the wash).
Information
–
170
Programme abortion
172
Switch on anti-frost device
175
Error “trailer coupling recognised”
200
Control voltage absent (e.g. emergency-stop button off, engine protection switch)
Press emer-
gency-stop but-
ton, trigger off
engine protec-
tion switch
Unlock all
emergency-
stop buttons,
reset engine
protection
switch.
201
Plant not in operation (operational time switched off)
Night operation
lock active
Wait until the
night operation-
al pause is over
or reset time-
switch clock.
202
Do not drive out vehicle (Exit Timer)
Vehicle in the
plant, light bar-
riers dirty/de-
fective
Drive vehicle
out of the plant,
clean light barri-
ers.
203
Portal not in normal setting
Plant not in nor-
mal setting, In-
terference in
control
Drive vehicle
out of the plant,
press button
Normal Set-
ting, repeat
wash proce-
dure.
204
Portal not in normal setting
205
Side-brushes not facing outwards
206
Side-brush 1 not facing outwards
207
Side-beam not facing outwards
208
Roof brush not facing above
209
Drier is not above
210
Wheel wash brushes not facing outwards
211
Wheel wash brush 1 not facing outwards
212
Wheel wash brush 2 not facing outwards
