Мойки высокого давления Karcher CB 1 25 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
28
English
Dis-
play
Fault
Possible
cause
Remedy
1
Limit switch Drive start/Drive end iIlogically allocated
Limit switch al-
located or de-
fective via
foreign metal
part
Remove foreign
part.
4
Limit switch side-brush 1 inside/outside iIlogically allocated
5
Limit switch side-brush 2 inside/outside iIlogically allocated
6
Limit switch roof brush above/below iIlogically allocated
10
Limit switch roof drier above/below iIlogically allocated
50
Travel command has been given but gantry travel start (GTS) limit switch has not been ex-
ited
Failure in the
control.
Drive vehicle
out of the plant,
switch off main
switch, wait for
10 seconds,
switch on main
switch again,
press Reset
button, press
button Normal
setting, repeat
washing proce-
dure.
51
Gantry travel start (GTS) limit switch not reached
52
Travel command has been given but gantry travel end (PFE) limit switch has not been exited
53
Gantry travel end (PFE) limit switch not reached
54
Travel command has been given but side brush 1 start (SB1_a) limit switch has not been
exited
55
Limit switch for side brush 1 start (SB1_a) not reached
56
Travel command has been given but side brush 1 end (SB1_e) limit switch has not been
exited
57
Limit switch for side brush 1 end (SB1_e) not reached
58
Travel command has been given but side brush 2 start (SB2_a) limit switch has not been
exited
59
Limit switch for side brush 2 start (SB2_a) not reached
60
Travel command has been given but side brush 2 end (SB2_e) limit switch has not been
exited
61
Limit switch for side brush 2 end (SB2_e) not reached
62
Travel command has been given but top roof brush limit switch (DBO) has not been exited
63
Upper roof brush limit switch (DBO) not reached
66
Travel command has been given but lower roof brush limit switch (DBU) has not been exited
67
Lower roof brush limit switch (DBU) not reached
68
Travel command has been given but upper roof drier limit switch (TRO) has not been exited
69
Upper top roof drier limit switch (TRO) not reached
70
Travel command has been given but lower roof drier limit switch (TRU) has not been exited
71
Lower roof drier limit switch (TRU) not reached
80
Roof brush adjustment, power measurement too high
81
Roof brush adjustment, power measurement too low
82
Roof brush adjustment, power measurement deviation from previous value too high
83
Roof brush power take-up during the wash too low
84
Side-brush 1 alignment, power measurement too high
85
Side-brush 1 alignment, power measurement too low
86
Side brush 1 alignment, power measurement deviates too greatly from previous value
87
Side brush 1 power take-up during the wash too low
88
Side-brush 2 alignment, power measurement too high
89
Side-brush 2 alignment, power measurement too low
86
Side brush 2 alignment, power measurement deviates too greatly from previous value
91
Side brush 2 power take-up during the wash too low
