Omron HBP-1100 - Инструкция по эксплуатации - Страница 39

37

EN

Immunity test IEC60601-1-2 

test level

Compliance 

level

Electromagnetic environment - 

guidance

Conducted RF

IEC 61000- 4-6

Radiated RF

IEC 61000- 4-3

3 Vrms

150 kHz to 

80 MHz

80% AM (2Hz)

3 V/m

80 MHz to 

2.5 GHz

80% AM (2Hz)

3 Vrms

3 V/m

Portable and mobile RF 

communications equipment 

should be used no closer to any 

part of the HBP-1100, including 

cables, than the recommended 

separation distance calculated 

from the equation applicable to 

the frequency of the transmitter.

Recommend separation distance

d = 1,2

P

150 kHz - 80 MHz

d = 1,2

P

80 MHz - 800 MHz

d = 2,3

P

800 MHz - 2,5 GHz

where 

P

 is the maximum output 

power rating of the transmitter 

in watts (W) according to he 

transmitter manufacturer and d 

is the recommended separation 

distance in meters (m).
Field strengths from fixed RF 

transmitters as determined 

by an electromagnetic site 

survey*, should be less than 

the compliance level in each 

frequency range**.
Interference may occur in the 

vicinity of equipment marked with 

the following symbol:

Note1:

At 80 MHz and 800 MHz, the higher frequency range applies.

Note2:

These guidelines may not apply in all situations. Electromagnetic 

propagation is affected by absorption and reflection from structures, 

objects, and people.

 *Field strengths from fixed transmitters, such as base stations for radio (cellular/

cordless) telephones and land mobile radios, amateur radio, AM and FM radio 

broadcast and TV broadcast cannot be predicted theoretically with accuracy. 

To assess the electromagnetic environment due to fixed RF transmitters, 

an electromagnetic site survey should be considered. If the measured field 

strength in the location in which the HBP-1100 is used exceeds the applicable 

RF compliance level above, the HBP-1100 should be observed to verify normal 

operation. If abnormal performance is observed, additional measures may be 

necessary, such as reorienting or relocating the HBP-1100.

**

Over the frequency range 150 kHz to 80MHz, field strengths should be less than 3 V/m.