Pioneer VSX-920 / VSX-1020 / VSX-1025 - Инструкция по эксплуатации - Страница 81

Controlling the rest of your system

09

81

En

English

Français

Deutsch

Nederlands

Italiano

Español

Multi operation and System off

The Multi operation feature allows you to 

program a series of up to 5 commands for the 

components in your system. 

• Be sure to call up the preset codes of 

devices or perform programming signals 

for other remote controls before multi 
operation memory programming (page 78).

The Multi operation feature makes it easy to 
perform the following operations by pressing 

just two buttons.
Press 

MULTI OPERATION

 and then the 

DVD

input function button to:
1. Switch this receiver on.

2. Switch this receiver’s input to DVD.
3. Transmit a sequence of up to five 
programmed commands.
Similar to Multi operations, System off allows 

you to use two buttons to stop and switch off a 

series of components in your system at the 

same time.

1

 Only one System off operation 

sequence may be programmed.
Press 

MULTI OPERATION

 and then 

 

SOURCE

to:
1. Transmit a sequence of up to five 

programmed commands.

2. Switch off all Pioneer devices including the 

receiver (except DVD recorders and VCRs).
For greater convenience, program this receiver 

to perform power on/off and playback 

operations on non-Pioneer devices as well.

2

(The signals for Pioneer devices described 

above are not contingent on programming for 

non-Pioneer devices.)

The buttons that can be programmed using 

Multi operation or System off are the same 

buttons as those that can be programmed for 
other remote controls (see 

Programming 

signals from other remote controls

 on page 78).

Programming a Multi operation or a 
shutdown sequence

1

Press and hold R.SETUP, then press “3” 

for three seconds.

The LED flashes continuously.

• To cancel the preset setup mode press 

R.SETUP

.

2

Press the input function button (or 

 

SOURCE button).

For Multi operations,

 press the input function 

you wish to program (for example, if you want 

to start the sequence by switching on your 

DVD player, press 

DVD

).

3

For System off,

 press the 

 

SOURCE

 button.

The LED blinks twice and flashes 

continuously.

3

If necessary, press the input function 

button for the component whose command 
you want to input.

This is only necessary if the command is for a 

new component (input function).

4

Select the button for the command you 

want to input.

The LED blinks once and flashes continuously.

• You don’t need to program the receiver to 

switch on or off. This is done automatically.

Note

1 • Before Multi operation and System off will work correctly, you must setup the remote to work with your TV and other 

components (see 

Operating multiple receivers

 on page 77 for more on this).

• Some units may take some time to power up, in which case multiple operations may not be possible.

• Power on and off commands only work with components that have a standby mode.

2 Some remote controllers for other manufacturers' devices use the same signals for switching the power on and off. 

In some cases, even if this receiver is programmed to perform these commands, power to the non-Pioneer devices 

may not be switched on and off correctly. Program the receiver to perform these commands if the non-Pioneer device 

uses separate signals for power on/off.

3 With Multi operation, the 

HDMI

 and 

TV CTRL

 settings cannot be made, but the 

iPod USB

 settings can. For other 

settable input functions, see 

Setting the remote to control other components

 on page 77.

VSX-1020_SYXCN.book  81 ページ  

年

月

日　金曜日　午前９時

分