Усилители Pioneer VSX-920 / VSX-1020 / VSX-1025 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Controlling the rest of your system
09
77
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 9:
Controlling the rest of your
system
Operating multiple receivers
Up to four receivers can be operated discretely
using this receiver’s remote control when
using multiple receivers, provided they are of
the same model as this receiver. The receiver to
be operated is switched by inputting the preset
code to set the remote control setting.
• Set the remote modes on the receivers
before using this function (see
Remote
Control Mode Setup
on page 107).
1
Press and hold R.SETUP, then press “4”
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP
.
2
Press the number button for the receiver
(“Receiver 1” to “Receiver 4”) you wish to
operate.
For example, to operate “Receiver 2”, press “
2
”.
If the LED lights for one second, the setting has
been successfully completed.
When the preset code is input, the LED flashes
three times to indicate that the setting has
failed.
Setting the remote to control
other components
Most components can be assigned to one of
the input function buttons (such as
DVD
or
CD
) using the component’s manufacturer
preset code stored in the remote.
However, there are cases where only certain
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still
teach the remote individual commands from
another remote control (see
Programming
signals from other remote controls
on page 78).
Note
• You can cancel or exit any of the steps by
pressing
R.SETUP
.
• After one minute of inactivity, the remote
automatically exits the operation.
• For greater convenience, assign the TV
connected to the MONITOR OUT terminal
to the
TV CTRL
button, and assign your
satellite/cable receiver or set-top box
connected to the TV input terminal to the
TV
input button. If a single device is
connected to both terminals, that device
should be assigned to both the
TV CTRL
and
TV
input buttons.
• Devices may be assigned to the following
input function buttons.
INPUT SELECT
ZONE 2
iPod USB TUNER
VIDEO TV CTRL
ADAPTER
NET RADIO
CD
TV
BD
DVD
R.SETUP
SOURCE
RECEIVER MULTI
OPERATION
DVR/BDR
HDMI
RECEIVER
VSX-1020_SYXCN.book 77 ページ
年
月
日 金曜日 午前９時
分
