Усилители Pioneer VSX-920 / VSX-1020 / VSX-1025 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Controlling the rest of your system
09
79
En
English
Français
Deutsch
Nederlands
Italiano
Español
3
Point the two remote controls towards
each other, then press the button that will be
doing the learning on this receiver’s remote
control.
The LED blinks once and flashes continuously.
• The remote controls should be 3 cm apart.
4
Press the corresponding button on the
other remote control that is sending (teaching)
the signal to this receiver’s remote control.
If the LED lights for one second, the setting has
been successfully completed.
1
5
To program additional signals for the
current component repeat steps 3 and 4.
To program signals for another component,
exit and repeat steps 2 through 4.
6
Press R.SETUP to exit the programming
mode.
Erasing one of the remote
control button settings
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1
Press and hold R.SETUP, then press “7”
for three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP
.
2
Press the input function button
corresponding to the command to be erased,
then press ENTER.
The LED flashes once.
3
Press and hold the button to be erased
for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
4
Repeat step 3 to erase other buttons.
5
Press R.SETUP to exit the erasing mode.
Note
1 • Note that interference from TVs or other devices will sometimes result in the remote control learning the wrong
signal.
• Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be
moved closer together or farther apart.
• If the LED flashes for five seconds, it means the memory is full. See
Resetting the input assignment
of one of the
input function buttons
above to erase a programmed button you’re not using to free up more memory (note that some
signals may take more memory than others).
3 cm
This receiver’s
remote control
Other remote
control
VSX-1020_SYXCN.book 79 ページ
年
月
日 金曜日 午前９時
分
