Усилители Pioneer VSX-920 / VSX-1020 / VSX-1025 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Additional information
12
111
En
English
Français
Deutsch
Nederlands
Italiano
Español
Noise is output when
scanning a DTS CD.
• This is not a malfunction of the receiver. The scan function of your player
alters the digital information, making it unreadable, resulting in noise being
output. Lower the volume when scanning.
When playing a DTS format
LD there is audible noise on
the soundtrack.
• Make sure that the input signal type is set to
DIGITAL
(see
Choosing the input
signal
on page 61).
Can’t record audio.
• You can only make a digital recording from a digital source, and an analog
recording from an analog source.
• For digital sources, make sure that what you’re recording isn’t copy protected.
• Check that the
OUT
jacks are properly connected to the recorders input jacks
(see
Connecting other audio components
on page 30).
Subwoofer output is very low. • To route more signal to the subwoofer, set it to
PLUS
or set the front speakers
to
SMALL
(see
Speaker Setting
on page 102).
Everything seems to be set up
correctly, but the playback
sound is odd.
• The speakers may be out of phase. Check that the positive/negative speaker
terminals on the receiver are matched with the corresponding terminals on the
speakers (see
Connecting the speakers
on page 20).
The
PHASE CONTROL
feature doesn’t seem to have
an audible effect.
• If applicable, check that the lowpass filter switch on your subwoofer is off, or
the lowpass cutoff is set to the highest frequency setting. If there is a
PHASE
setting on your subwoofer, set it to 0º (or depending on the subwoofer, the
setting where you think it has the best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers (see
Speaker
Distance
on page 103).
Noise or hum can be heard
even when there is no sound
being input.
• Check that personal computers or other digital components connected to the
same power source are not causing interference.
Can’t select some Input
functions by the
INPUT
SELECTOR
on the front panel
or the
INPUT SELECT
button
on the remote control.
• Check the Input Skip settings in the Input Setup menu.
• Check the HDMI Input assignment in the Input Setup menu then try OFF.
There seems to be a time lag
between the speakers and
the output of the subwoofer.
• See
Automatically conducting optimum sound tuning (Auto MCACC)
on
page 39 to set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
The maximum volume
available (shown in the front
panel display) is lower than
the
+12dB
maximum.
• Check that the Volume Limit is set to
OFF
(see
Volume Setup
on page 106).
• The channel level setting may be over
0dB
.
Symptom
Remedy
VSX-1020_SYXCN.book 111 ページ
年
月
日 金曜日 午前９時
分
