Усилители Pioneer VSX-920 / VSX-1020 / VSX-1025 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Additional information
12
108
En
Chapter 12:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized independent service company to carry out repair work.
Note
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Power
Symptom
Remedy
The power does not turn on. • Make sure that the power cord is plugged in to an active power outlet.
• Try disconnecting from the power outlet, then plugging back in.
Power cannot be turned off.
(
ZONE 2
ON
is displayed.)
• Set the remote control’s
MULTI-ZONE
operation selector switch to
ZONE 2
,
then press
RECEIVER
to switch the Zone 2 off.
The receiver suddenly
switches off or the
iPod
iPhone
indicator blinks.
• Check that there are no loose strands of speaker wire touching the rear panel
or another set of wires. If so, re-attach the speaker wires, making sure there are
no stray strands.
• The receiver may have a serious problem. Disconnect from the power and call
a Pioneer authorized independent service company.
During loud playback the
power suddenly switches off.
• Turn down the volume.
• Lower the 63 Hz and 125 Hz equalizer levels in the
Manual MCACC setup
on
page 90.
• Switch on the digital safety feature. While holding down
ENTER
on the front
panel, press
STANDBY/ON
to set this receiver to the standby mode. Use
TUNE
/
to select
D.SAFETY
OFF
, and then use
PRESET
/
to select
1
or
2
(select
D.SAFETY
OFF
to deactivate this feature). If the power
switches off even with
2
switched on, turn down the volume. With
1
or
2
on,
some features may be unavailable.
The unit does not respond
when the buttons are
pressed.
• Try switching the receiver off, then back on again.
• Try disconnecting the power cord, then connect again.
VSX-1020_SYXCN.book 108 ページ
年
月
日 金曜日 午前９時
分
