NETGEAR S3300-28X (GS728TX) 24x1GE - Инструкция по эксплуатации - Страница 306

Maintenance 

306

S3300 Smart Managed Pro Switch 

Figure 111. Ping IPv4

2. 

In the 

IP Address/Host Name

 field, specify the IP address or Hostname of the station you 

want the switch to ping. The initial value is blank. The IP Address or Hostname you enter is 
not retained across a power cycle.

3. 

Optionally, configure the following settings:

•

In the 

Count

 field, specify the number of pings to send. The default value is 3. The 

range is 1 to 15. The Count you enter is not retained across a power cycle.

•

In the 

Interval

 field, specify the number of seconds between pings sent. The default 

value is 3 seconds. The range is 1 to 60. The Interval you enter is not retained across 
a power cycle.

•

In the 

Size

 field, specify the datagram size of the ping (ICMP) packet to send. The 

default value is 0 bytes. The range is 0 to 65507. The Size you enter is not retained 
across a power cycle.

4. 

In the 

Source

 field, select the source type from which the ping is sent, which is one of the 

following:

•

None

 — The source is the IP address of the default outgoing interface. If source is not 

required, select None as the source option.

•

IP Address

 — The source is an IP address that you specify. If you select this option, 

the IP Address

field appears. Specify the source IP address of the ping in the IP 

address field.

•

Interface

 — The ping is sent from a specified interface to use when sending the Echo 

request packets. If you select this source option, the Interface field is shown. Use the 
menu to select the interface from which to send the ping.

Note:

Values configured in the fields above are not saved to the switch. As a 
result, refreshing the page sets these fields to the default values.