STIGA MULTICLIP 547 D 298471848/ST2 - Инструкция по эксплуатации - Страница 83

7

• 

The frequency and type of procedures 

are outlined in the "Maintenance table".

•  The use of non-original parts and accessories 

could have negative effects on machine 

operation and safety. The manufacturer 

declines any responsibility for damage 

or injury caused by said products.

• 

Original parts are supplied by assistance 

shops and authorised dealers.

 IMPORTANT 

 All maintenance and adjustment 

oper

ations that are not described in this manual must 

be carried out by your Dealer or by a Specialised Centre.

 5.2  MAINTENANCE TABLE

 IMPORTANT 

  It  is  the  responsibility  of  the 

owner to perform the machine maintenance 

operations described in the table below.

 IMPORTANT 

  Clean  more  frequently  when 

operating in particularly demanding conditions or 

when there is debris in the air.

 NOTE 

  Filters  should  be  cleaned  /  replaced 

more  often  if  the  machine  is  used  on  very  dusty 

ground.

Operation

After the first 5 hours

Ev

er

y 5 hours

or after e

ver

y use

Ev

er

y 50 

hour

s or

 at 

the 

end 

of 

the 

season

Ev

er

y 100 hours

Oil level check (par. 4.1.1)

-

√

-

-

Oil change

1

 (par. 5.4)

√

-

√

-

Cleaning the silencer and 

the engine (par. 5.5)

-

√

-

-

Checking and cleaning 

the air filter 

2

(par. 5.6)

-

√

-

-

Changing the air 

filter (par. 5.6)

3

-

-

-

√

Spark plug check (par. 5.7)

-

-

√

-

Changing spark 

plugs (par. 5.7)

-

-

-

√

1  

Change the oil every 25 hours if the engine is 

operating under heavy load or in hot weather.

2  

Clean the air filter more frequently if the 

machine is operating in dusty areas.

3  

Only for the filtering element provided 

in the form of a cartridge.

 5.3 

BATTERY (IF APPLICABLE)

To ensure long life to the battery it is 

essential to keep it carefully maintained.

The machine battery must always be charged:

• 

before using the machine for the 

first time after purchase;

• 

before leaving the machine disused for 

a long period (over 30 days) (par. 4.5);

• 

before starting up the machine after 

a prolonged period of inactivity.

IMPORTANT

  If  unused  for  any  length  of  time, 

recharge the battery every two months to prolong 

its working life.

Failure in following the procedure or in 

charging the battery could permanently 

damage the battery elements. A flat battery 

must 

be recharged as soon as possible.

 IMPORTANT 

  The battery must be 

charged exclusively using the battery 

charger (fig. 7.C). Other recharging systems 

can irreversibly damage the battery.

 5.3.1 

Battery removal and recharging

To remove the battery: 

• 

Push the button placed above the battery 

by making it slide upwards (fig. 6.A).

To recharge the battery:

• 

Remove the rubber cap placed on 

the battery's lower side (fig 7.B)

• 

connect the battery charger (fig. 7.C) 

to a power socket with the voltage 

indicated on the rating plate.

• 

Once the battery is connected the 

battery charger's light will light up (fig 

7.F): a red light means that the battery 

is recharging, whereas a green light 

means that the recharging is complete.

 NOTE 

 The battery is equipped with a guard 

that inhibits recharging if the environmental 

temperature is not between 0 and +45 °C.