Ryobi RBC30SESB 5133002410 - Инструкция по эксплуатации - Страница 69

20

English (Original instructions)

■

Insert one end of the string into the eyelet located 
on the side of the string head and push until string 
comes out through eyelet on the other side. Continue 
to push string through the string head until the middle 
section of the string is inside the string head and 
string outside the string head is evenly divided on 
each side.

■

Rotate the knob on the string head clockwise to wind 
the string.

■

Wind the string until approximately 20cm remains 
protruding from the string head.

BLADE PROTECTOR (Fig. 10)

Always place the blade protector on the blade when the 
unit is not in use. The blade protector has clips round the 
edges to snap over the blade and keep it in place. Wear 
gloves and be cautious when handling the blade.

NOTE: 

Always remove the blade protector before 

using the unit. If not removed, the blade protector could 
become a thrown object as the blade begins to turn.

C L E A N I N G   T H E   E X H A U S T   P O R T   A N D 
SILENCER

Depending on the type of fuel used, the type and amount 
of lubricant used, and/or your operating conditions, the 
exhaust port and silencer may become blocked with 
carbon deposits. If you notice a power loss with your 
petrol powered tool, a qualified service technician will 
need to remove these deposits to restore performance.

SPARK ARRESTOR

It is recommended to clean or replace the spark arrestor 
every 25 hours to ensure proper performance of your 
product. Spark arrestors may be in different locations 
depending on the model purchased. Please contact 
your nearest service dealer for the location of the spark 
arrestor for your model.

ATTACHING THE HANGER CAP (Fig. 11)

To use the hanger cap, push in the button and place the 
hanger cap over the lower end of the attachment. Slightly 
rotate the cap from side to side until the button locks into 
place.

NOTE: 

The secondary hole in the attachment shaft can 

be used for hanging purposes as well.

CLEANING THE AIR FILTER SCREEN (Fig. 12)

For proper performance and longer life, keep the air filter 
screen clean.

■

Remove the air filter cover by pushing down the latch 
while gently pulling out the cover.

■

Brush the air filter screen lightly.

■

Replace the air filter cover by inserting the tabs of the 
cover into the slots on the air filter base, then push 
the cover up until it latches securely in place.

FUEL CAP

WARNING

 A leaking fuel cap is a fire hazard and must be 

replaced immediately.

SPARK PLUG (Fig. 13)

This engine uses a Champion RCJ-6Y or equivalent 
spark plug with 0.63 mm electrode gap. Use an exact 
replacement.

STORAGE (1 MONTH OR LONGER)

■

Drain all fuel from tank into a container approved 
for fuel. Run engine until it stops.

■

Clean all foreign material from the trimmer. Store it in 
a well-ventilated place that is inaccessible to children. 
Keep away from corrosive agents such as garden 
chemicals and de-icing salts.

■

Abide by all ISO and local regulations for the safe 
storage and handling of fuel. Excess fuel should be 
used up in other 2-stroke engine powered equipment.