Hitachi CS33EDT - Инструкция по эксплуатации - Страница 9

8

English

WARNINGS

AND

SAFET Y

INSTRUCTIONS

Operator

safety

WARNING

This

chain

saw

(CS33EDT)

is

designed

especially

for

tree

care

and

surgery.

Only

persons

trained

in

tree

care

and

surgery

may

use

this

saw.

Observe

all

literature,

procedures

and

recommendations

from

the

relevant

professional

organization.

Failure

to

do

so

constitutes

a

high

accident

risk.

We

recommend

always

using

a

rising

platform

for

sawing

in

trees.

Rappelling

techniques

are

extremely

dangerous

and

require

special

training.

The

operator

must

be

trained

in

and

familiar

with

the

use

of

safety

equipment

and

working

and

climbing

techniques.

Always

use

the

restraining

equipment

for

both

the

operator

and

the

saw.

○

  Always use the gloves to reduce the e

ff

 ects of vibration

○

  Always wear a safety face shield or goggles.

○

  Gloves should be used when sharpening chain.

○

  Always wear safety protective equipment such as jacket, 

trousers, gloves, helmet, boots with steel toe-caps and non-slip 
soles whenever you use a chain saw. For working in trees the 
safety boots must be suitable for climbing techniques. Do not 
wear loose clothing, jewelr y, shor t pants, sandals or go barefoot.

Secure hair so it is above shoulder length.

○

  Do not operate this tool when you are tired, ill or under the 

in

fl

 uence of alcohol, drugs or medication.

○

  Never let a child or inexperienced person operate the machine.

○

  Wear hearing protection. Pay attention to your surroundings.

Be aware of any bystanders who may be signaling a problem.

Remove safety equipment immediately upon shutting o

ff

  engine.

○

  Wear head protection.

○

  Never star t or run the engine inside a closed room or building.

Breathing exhaust fumes can kill.

○

  For respirator y protection, wear a protection mask while emitting 

the chain oil mist and dust from sawdust.

○

  Keep handles free of oil and fuel.

○

  Keep hands away from cutting equipment.

○

  Do not grab or hold the unit by the cutting equipment.

○

  When the unit turned o

ff

 , make sure the cutting attachment has 

stopped before the unit is set down.

○

  When operation is prolonged, take a break from time to time 

so that you may avoid possible Hand-Arm Vibration Syndrome 
(HAVS) which is caused by vibration.

○

  The operator must obey the local regulations of cutting area.

WARNING

○

  Anti-vibration systems do not guarantee that you will not sustain 

Hand-Arm Vibration Syndrome or carpal tunnel syndrome.

Therefore, continual end regular users should monitor closely 
the condition of their hands and 

fi

 ngers. If any of the above 

symptoms appear, seek medical advice immediately.

○

  Long or continuous exposure to high noise levels may cause 

permanent hearing impairment. Always wear approved hearing 
protection when operating a unit /machine.

○

  If you are using any medical electric/electronic devices such 

as a pacemaker, consult your physician as well as the device 
manufacturer prior to operating any power equipment.

Unit /machine

safety

○

  Inspect the entire unit /machine before each use. Replace 

damaged par ts. Check for fuel leaks and make sure all fasteners 
are in place and securely tightened.

○

  Replace par ts that are cracked, chipped or damaged in any way 

before using the unit /machine.

○

  Make sure the side case is properly attached.

○

  Keep others away when making carburetor adjustments.

○

  Use only accessories as recommended for this unit /machine by 

the manufacturer.

○

  Never let the chain strike any obstacle. If the chain makes 

contact, the machine should be stopped and checked carefully.

○

  Make sure the automatic oiler is working. Keep the oil tank 

fi

 lled 

with clean oil. Never let chain run dr y on the bar.

○

  All chain saw ser vice, other than the items listed in the 

operator

ʼ

s/ owner

ʼ

s manual, should be per formed by competent 

chain-saw ser vice personnel. (For example, if improper tools are 
used to remove the 

fl

 ywheel or if an improper tool is used to hold 

the 

fl

 ywheel in order to remove the clutch, structural damage 

to the 

fl

 ywheel could occur and could subsequently cause the 

fl

 ywheel to burst.)

WARNING

○

  Never modify the unit /machine in any way. Do not use your unit /

machine for any job except that for which it is intended.

○

  Never use chain saw without any safety equipment or that has 

faulty safety equipment. It could result in serious personal injur y.

○

  Using guide bar/chain other than recommended by the 

manufacturer which are not approved, could result in a high risk 
of personal accidents or injur y.

Fuel

safety

○

  Mix and pour fuel outdoors and where there are no sparks or 

fl

 ames.

○

  Use a container approved for fuel.

○

  Do not smoke or allow smoking near fuel or the unit /machine or 

while using the unit /machine.

○

  Wipe up all fuel spills before star ting engine.

○

  Move at least 3 m away from fueling site before star ting engine.

○

  Stop engine and let it cool for a few minutes before removing fuel 

tank cap.

○

  Empty the fuel tank before storing the unit /machine. It is 

recommended that the fuel be emptied after each use. If fuel is 
left in the tank, store so fuel will not leak.

○

  Store unit /machine and fuel in area where fuel vapors cannot 

reach sparks or open 

fl

  ames from water heaters, electric motors 

or switches, furnaces, etc.

WARNING

Fuel is easy to ignite or get explosion or inhale fumes, so that pay 
special attention when handling or 

fi

 lling fuel.

Cutting

safety

○

  Do not cut any material other than wood or wooden objects.

○

  For respirator y protection, wear an aerosol protection mask 

when cutting the wood after insecticide has been applied.

○

  Keep others including children, animals, bystanders and helpers 

outside the hazard zone. Stop the engine immediately if you are 
approached.

○

  Hold the unit /machine 

fi

 rmly with the right hand on the rear 

handle and the left hand on the front handle.

○

 Keep 

fi

 rm footing and balance. Do not over-reach.

○

  Keep all par ts of your body away from the mu

ffl

  er  and  cutting 

attachment when the engine is running.

○

  Keep Bar/Chain below waist level.

○

  Before felling a tree, the operator must be accustomed to the 

sawing techniques of the chain saw.

○

  Be sure to pre-plan a safe exit from a failing tree.

○

  While cutting, hold saw 

fi

 rmly with both hands with thumb 

fi

 rmly 

locked around front handle, and stand with feet well balanced 
and your body balanced.

○

  Stand to the side of the saw when cutting - never directly behind it.

○

  Always keep the spiked bumper face to a tree, because the 

chain may suddenly be drawn into a tree, if so equipped.

○

  When completing a cut, be ready to hold up the units as it breaks 

into clear, so it will not follow through and cut your legs, feet or 
body, or contact an obstruction.

○

  Be aler t against kickback (when saw kicks up and back at 

operator). Never cut with the nose of the bar.

○

  When  relocating  to  a  new  work  area,  be  sure  to  shut  o

ff

   the 

machine and ensure that all cutting attachments are stopped.

○

  Never place the machine on the ground when running.

○

  Always  ensure  that  the  engine  is  shut  o

ff

  and any cutting 

attachments have completely stopped before clearing debris or 
removing grass from the cutting attachment.

○

  Always carr y a 

fi

  rst-aid kit when operating any power equipment.

○

  Never star t or run the engine inside a closed room or building 

and/or near the in

fl

 ammable liquid. Breathing exhaust fumes 

can kill.

000Book̲CS33EDT̲EE.indb   8

000Book̲CS33EDT̲EE.indb   8

2011/08/06   8:57:17

2011/08/06   8:57:17