Flymo Contour 500 XT 9669524-62 - Инструкция по эксплуатации - Страница 30

TROUBLESHOOTING

29

PROBLEM

LOOK FOR

REMEDY

Engine will not turnover 

or start.

Brake pedal not depressed.

Fully depress brake pedal. 

PTO (electric clutch) switch is in
ON position.

Place in OFF position.

Cruise control engaged.

Move knob to NEUTRAL/OFF position.

Out of fuel.

If engine is hot, allow it to cool, then refill the fuel tank.

Engine flooded.

Disengage the choke.

Fuse is blown.

See authorized dealer.

Battery terminals require
cleaning.

See 

Cleaning the Battery and Cables section.

Battery discharged or dead.

Recharge or replace battery.

Wiring loose or broken.

Visually check wiring. If wires are frayed or broken, see authorized dealer.

Solenoid or starter motor faulty. See authorized dealer.
Safety interlock switch faulty.

See authorized dealer.

Water in fuel.

See authorized dealer.

Gas is old or stale.

See authorized dealer.

Engine starts hard or runs

poorly.

Fuel mixture too rich.

Clean air filter.

Engine has other problem.

See authorized dealer.

Engine knocks.

Low oil level.

Check/add oil as required.

Using wrong grade oil.

See 

Oil Recommendations Chart.

Excessive oil consumption.

Engine running too hot.

See authorized dealer.

Using wrong grade oil.

See 

Oil Recommendations Chart.

Too much oil in crankcase.

Drain excess oil.

Engine exhaust is black.

Dirty air filter.

See 

Servicing the Air Filter section.

Choke closed.

Open choke.

Engine runs, but tractor

will not drive.

Ground speed control pedals
not depressed.

Depress pedals.

Transmission release lever in
PUSH position.

Move into DRIVE position.

Mower drive belt is broken.

See authorized dealer.

Parking brake is engaged.

Disengage parking brake.

Traction drive belt is broken or
slipping.

See authorized dealer.

Troubleshooting the Tractor

Not for  

Reproduction