KitchenAid 5KSM7591XEOB - Инструкция по эксплуатации - Страница 7

7

English

Setting up your Stand Mixer

Adjusting your Beater to Bowl Clearance 

Your Stand Mixer is adjusted at the factory so the Flat Beater just clears the bottom of the 

bowl. If, for any reason, the Flat Beater hits the bottom of the bowl or is too far away from 

the bowl, you can correct the clearance easily.

 1.  Turn speed control to “0” (OFF).
  2.  Unplug Stand Mixer or disconnect power. 
  3.  Lower the bowl to the down position.
  4.   Turn Beater Height Adjustment Screw (A) slightly counter clockwise (left)  

to raise Flat Beater or clockwise (right) to lower Flat Beater.

  5.   Make adjustment with Flat Beater, so it just clears surface of the bowl.  

If you over adjust the screw, the Bowl Lift Lever may not lock into place.

NOTE:

 When properly adjusted, the 

Flat Beater will not strike on the bottom 

or side of the bowl. If the Flat Beater or 

the Stainless Steel Whip is so close that it 

strikes the bottom of the bowl, coating 

may wear off the Flat Beater (for coated 

beaters) or wires on Stainless Steel Whip 

may wear.
Scraping sides of bowl may be necessary 

under certain conditions regardless of 

beater adjustment. The Stand Mixer must 

be stopped to scrape bowl or damage to 

mixer may occur.

W10421400A_1_EN.indd   7

11/15/11   1:47 PM