KitchenAid 5KSM7591XEOB - Инструкция по эксплуатации - Страница 6

6

English

Setting up your Stand Mixer

Assembling your Bowl-Lift Stand Mixer 

To attach the Stainless Steel Bowl

Turn speed control to “0” (OFF). Unplug Stand Mixer or disconnect  

power. Place Bowl Lift Lever into down position. Fit Bowl Supports  

over Locating Pins and press down on back of the bowl until the  

Bowl Pin snaps into the Spring Latch. (Fig. 1) 

IMPORTANT:

 If the bowl is not securely snapped into place, it will  

be unstable and wobble during use.

To raise the Stainless Steel Bowl to mixing position

Rotate Bowl Lift Lever counterclockwise to the straight up position. (Fig. 2)  

The bowl must always be in the raised position when mixing. 

To remove the Stainless Steel Bowl

Turn speed control to “0” (OFF). Unplug Stand Mixer or disconnect  

power. Place Bowl Lift Lever in down position. Grasp Bowl Handle  

and lift straight up and off Locating Pins.

To attach Flat Beater, Stainless Steel Whip,  

or Spiral Dough Hook.

Turn speed control to “0” (OFF). Unplug Stand Mixer or disconnect  

power. Lower bowl by rotating Bowl Lift Lever downward. Slip beater  

on Beater Shaft and press upward as far as possible. Turn beater to right,  

hooking it over the Pin on the Beater Shaft.  

(Fig.3)

To remove Flat Beater, Stainless Steel Whip  

or Spiral Dough Hook

Turn speed control to “0” (OFF). Unplug Stand Mixer or disconnect  

power. Lower bowl by rotating Bowl Lift Lever downward. Press beater  

upward as far as possible and turn left. Pull beater from Beater Shaft.

To attach Pouring Shield

Turn speed control to “0” (OFF). Unplug Stand Mixer or disconnect  

power. Attach Flat Beater, Spiral Dough Hook, or Stainless Steel Whip  

and bowl. From the front of the mixer, slide the Pouring Shield over  

the bowl until the it is centered. The bottom rim of the Pouring Shield  

should fit within the bowl. (Fig. 4)

To use Pouring Shield

For best results, rotate the Pouring Shield so the Motor Head covers  

the U-shaped gap in the shield. The Pouring Chute will be just to the right  

of the  Attachment Hub as you face the mixer. Pour the ingredients into  

the bowl through the Pouring Chute.

Fig. 1

Locating Pin

Spring Latch

Pin

Fig. 2

Fig. 3

Fig. 4

Pouring 

Chute

W10421400A_1_EN.indd   6

11/15/11   1:47 PM