Smeg KC19RAE - Инструкция по эксплуатации - Страница 20

EN

8

Before performing any maintenance and/or cleaning always disconnect the hood 

from the power supply

Regular cleaning guarantees good operation and a long appliance service life. The 

grease filters and filter hoods with carbon filters require special care.

N.B. The accumulation of grease inside the filter panels as well as affecting the 

performance of the extractor, can also create a fire hazard.

FUNCTIONS AND MAINTENANCE: 

EXTERNAL CLEANING: 

The external and internal cleaning of the hood must be 

carried out using a damp cloth and mild liquid detergent. Completely avoid the use 

of  solvents  or  abrasives.  It  is  recommended  to  use  specific  products,  following  the 

instructions on the product. It is advisable to clean the hood by always rubbing the 

steel in the direction of the surface finish.

N.B. In some countries, the 4-speed version 

is also available, with the layout shown on the 

right, where:

 Filters Reset Key

Particular attention should be paid to the metal grease 

filter  panels.  The  accumulation  of  grease  inside  the 

filter panels as well as affecting the performance of the 

extractor, can also create a fire hazard.

In order to minimise the risk of fire, the filters must be 

cleaned regularly, at least once a month or with greater 

frequency in the case of a particularly intensive use of 

the appliance.

After identifying your hood model, remove one filter at 

a  time  as  shown  in  the  next  figure.  Thoroughly  wash 

filters  with  a  mild  detergent  either  by  hand  or  in  the 

dishwasher.  Replace  the  filters,  making  sure  that  the 

handle is on the outside of the hood

METAL FILTER CLEANING: 

The  carbon  filters  are  capable  of  retaining  odours 

until the carbon reaches 

saturation level

. They cannot be washed and they are not renewable, therefore, it is 

recommended to replace them at least every six months or more often if the hood is 

used often.

Before starting operations make sure the electrical power supply to the hood is 

disconnected.

Access the active carbon filters by removing the metal filters as described above. 

With the help of the figures, identify the carbon filters kit supplied with the hood.

REPLACING CARBON FILTERS:

 (Only for the filter version)