Bosch GWS 14 125 Inox - Инструкция по эксплуатации - Страница 31

32

 | English 

1 609 929 R00 | (21.4.08)

Bosch Power Tools

For cutting stone, it is best to use a diamond 
cutting disc. As a safety measure against jam-
ming, the cutting guide with dust extraction pro-
tection guard 

20

 must be used.

Operate the machine only with dust extraction 
and additionally wear a dust protection mask.
The vacuum cleaner must be approved for the 
extraction of masonry dust. Bosch provides suit-
able vacuum cleaners.

Switch on the ma-
chine and place 
the front part of 
the cutting guide 
on the workpiece. 
Slide the machine 
with moderate 
feed, adapted to 
the material to be 
worked.

For cutting expecially hard material, e. g., con-
crete with high pebble content, the diamond 
cutting disc can overheat and become damaged 
as a result. This is clearly indicated by circular 
sparking, rotating with the diamond cutting 
disc.
In this case, interrupt the cutting process and al-
low the diamond cutting disc to cool by running 
the machine for a short time at maximum speed 
with no load.
Noticeable decreasing work progress and circu-
lar sparking are indications of a diamond cutting 
disc that has become dull. Briefly cutting into 
abrasive material (e. g. lime-sand brick) can re-
sharpen the disc again.

Information on Structures

Slots in structural walls are subject to the 
Standard DIN 1053 Part 1, or country-specific 
regulations.
These regulations are to be observed under all 
circumstances. Before beginning work, consult 
the responsible structural engineer, architect or 
the construction supervisor.

Maintenance and Service

Maintenance and Cleaning

f

Before any work on the machine itself, pull 
the mains plug.

f

For safe and proper working, always keep 
the machine and ventilation slots clean.

f

In extreme working conditions, conductive 
dust can accumulate in the interior of the 
machine when working with metal. The pro-
tective insulation of the machine can be de-
graded. The use of a stationary extraction 
system is recommended in such cases as 
well as frequently blowing out the ventila-
tion slots and installing a residual current 
device (RCD).

Please store and handle the accessory(-ies) 
carefully.
If the machine should fail despite the care taken 
in manufacturing and testing procedures, repair 
should be carried out by an after-sales service 
centre for Bosch power tools.
In all correspondence and spare parts order, 
please always include the 10-digit article 
number given on the type plate of the machine.

WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.

The wires in the cable are coloured according to 
the following code:

Do 

not

 connect the blue or brown wire to the 

earth terminal of the plug.

Important:

 If for any reason the moulded plug is 

removed from the cable of this power tool, it 
must be disposed of safely.

OBJ_BUCH-611-003.book  Page 32  Monday, April 21, 2008  11:28 AM