Bosch GWS 14 125 Inox - Инструкция по эксплуатации - Страница 29

30

 | English 

1 609 929 R00 | (21.4.08)

Bosch Power Tools

Completely unscrew the four screws. Rotate the 
machine head carefully, 

without removing it 

from the housing,

 to the new position. Screw in 

and tighten the four screws again.

Dust/Chip Extraction

f

Dusts from materials such as lead-containing 
coatings, some wood types, minerals and 
metal can be harmful to one’s health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are 
considered as carcinogenic, especially in 
connection with wood-treatment additives 
(chromate, wood preservative). Materials 
containing asbestos may only be worked by 
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work-

ing place.

– It is recommended to wear a P2 filter-

class respirator.

Observe the relevant regulations in your 
country for the materials to be worked.

Operation

Starting Operation

f

Observe correct mains voltage! The voltage 
of the power source must agree with the 
voltage specified on the nameplate of the 
machine. Power tools marked with 230 V 
can also be operated with 220 V.

When operating the machine with power from 
mobile generators that do not have sufficient re-
serve capacity or are not equipped with suitable 
voltage control with starting current amplifica-
tion, loss of performance or untypical behavior 
can occur upon switching on.
Please observe the suitability of the power gen-
erator being used, particularly with regard to 
the mains voltage and frequency.

Switching On and Off

To 

start

 the power tool, push the On/Off switch 

4

 forwards.

To 

lock

 the On/Off switch 

4

, press the On/Off 

switch 

4

 down at the front until it latches.

To 

switch off

 the power tool, release the On/Off 

switch 

4

 or, if it is locked, briefly push down the 

back of the On/Off switch 

4

 and then release it.

f

Check grinding tools before using. The 
grinding tool must be mounted properly 
and be able to move freely. Carry out a test 
run for at least one minute with no load. Do 
not use damaged, out-of-centre or vibrating 
grinding tools. 

Damaged grinding tools can 

burst and cause injuries.

Kickback stop

In case of a sudden drop in speed, 
e.g., caused by a jammed disc 
while cutting, the power supply to 
the motor is electronically inter-
rupted.

To 

restart the operation

, switch the On/Off 

switch 

4

 to the Off position and start the ma-

chine again.

Restarting Protection

The restarting protection feature prevents un-
controlled restarting of the machine after an in-
terruption in the power supply.
To 

restart the operation

, switch the On/Off switch 

4

 to the Off position and start the machine again.

Reduced starting current

The electronic reduced starting current limits the 
power consumption when switching the tool on 
and enables operation from a 13 ampere fuse.

Constant Electronic Control

Constant electronic control holds the speed 
constant at no-load and under load, and ensures 
uniform working performance.

OBJ_BUCH-611-003.book  Page 30  Monday, April 21, 2008  11:28 AM