Gaggenau BS 484-111 - Инструкция по эксплуатации - Страница 35

3 5

Tr o u b l e   s h o o t i n g

Malfunctions of ten have  simple explanations. Please 
read the following notes before calling the af te r-sales 
s e r v i c e .

m

Risk of electric shock!

Incorrect repair s are dangerous. Repair s may only be 
c a r r i e d   o u t   a n d   d a m a g e d   p owe r   c a b l e s   r e p l a c e d   by   o n e  
o f   o u r   t r a i n e d   a f te r- s a l e s   te c h n i c i a n s .   I f   t h e   a p p l i a n c e   i s  
defective, unplug the appliance from the mains or switch 
of f the circuit breaker in the fuse box. Cont act the af te r-
s a l e s   s e r v i c e .

Disruption

Possible cause

Solution

Appliance not working, no display

Plug not inserted

Connect the appliance to the electricity 
mains

Power failure

Check whether other kitchen appliances 
are working

Fuse defective

Check in the fuse box whether the fuse 
for the appliance is in working order

Operating error

Switch off the fuse for the appliance in 
the fuse box and switch it on again after 
about 60 seconds

Appliance cannot be started

Appliance door is not quite closed

Close appliance door

The appliance is not working and the 
display does not respond.  

0

 appears 

on the display

Childproof lock activated

Deactivate the childproof lock (see sec-
tion entitled 'Childproof lock')

Appliance switches off on its own

Safety shut-off: the appliance has not 
been operated for longer than 12 hours

Confirm the message with 

™

, switch off 

the appliance and set it again.

Appliance does not heat up, 

°

 appears 

in the display

Appliance is in demo mode

Deactivate the demo mode in the basic 
settings

The appliance cannot be started, a mes-
sage is shown on the display

No water available in the appliance

Check the water connection

No steam visible in the oven

Steam above 100°C is invisible

This is normal

The grilling surface only lights up 
around the sides, not in the middle

Only the side of the grilling surface is 
heated to allow for better heat distribu-
tion

This is normal

The "steam removal" 

3 

symbol does not 

appear on the display

The steam removal function is only avail-
able if the oven temperature is below 
130°C

This is normal

A lot of steam escapes at the top of the 
door

Appliance is calibrating the boiling point 
or is preheating or the heating mode has 
been changed

This is normal

The appliance has not yet been cali-
brated

Calibrate the appliance

A lot of steam escapes at the side of the 
door

Door seal soiled or loose

Clean the door seal and insert it in the 
groove

Humming noise when switching on

The drain pump starts to operate

This is normal

Appliance has been switched off for sev-
eral days

This is normal: automatic rinsing when 
being switched on again

There is a "pop" noise during cooking

Cold/warm effect with frozen food, 
caused by the steam

This is normal

The appliance is not producing steam 
properly

Limescale has formed in the appliance

Start the descaling programme

The cooking compartment is wet after 
operation

This is normal depending on the operat-
ing mode set by the user

After operation, dry the cooking com-
partment using the drying programme