Yamaha RX-V563 - Инструкция по эксплуатации - Страница 29

27

 En

Optimizing the speaker setting for your listening room

English

PRE

P

ARA

T

ION

4

Make sure that “SETUP” is set to “AUTO” 
and the pointer is pointing at “START”.

y

You can also select the following setup methods. In this 
case, press 

7

k

 to select “SETUP”, press 

7

l

 / 

h

 to 

select the one of the following choises and then select 
“START”.

Choices: 

AUTO

, RELOAD, UNDO, DEFAULT

• Select “AUTO” to automatically run the entire 

“AUTO SETUP” procedure.

• Select “RELOAD” to reload the last “AUTO 

SETUP” settings and override the previous 
settings.

• Select “UNDO” to undo the last “AUTO SETUP” 

settings and restore the previous settings.

• Select “DEFAULT” to reset the “AUTO SETUP” 

parameters to the initial factory settings.

“RELOAD” or “UNDO” is available only when you have 
previously run “AUTO SETUP” and confirmed the results.

5

Press 

7

n

 to select “START” and then press 

7

ENTER

 to start the setup procedure.

The following message appears in the OSD.

6

Press 

7

ENTER 

to start the setup 

procedure.

This unit starts the auto setup procedure. Loud test 
tones are output from each speaker during the auto 
setup procedure. Once all items are set, the result 
display appears in the OSD.

• During the auto setup procedure, do not perform any 

operation on this unit.

• We recommend getting out of the room while this unit is in 

the auto setup procedure. It takes approximately 3 minutes 
for this unit to complete the auto setup procedure.

This unit performs the following checks:

Speaker wiring/volume level  

WIRING/LEVEL

Checks which speakers are connected and the 
polarity of each speaker. Also checks and adjusts the 
volume level of each speaker.

Speaker distance  

  DISTANCE

Checks the distance of each speaker from the 
listening position and adjusts the timing of each 
channel.

Speaker size  

  SIZE

Checks the frequency response of each speaker and 
sets the appropriate low-frequency crossover for each 
channel.

Note

Before proceeding next operation

Once you perform the next operation, this unit starts the 
automatic setup procedure. For more accurate 
measurements, keep quiet and move to the wall where 
speakers are not around. We recommend that you leave 
the listening room during the automatic setup 
procedure.

NOTICE

output.

Loudtesttonesare

Pleasekeepquiet

orleavetheroom.

Press[ENTER]

Notes