Yamaha RX-V563 - Инструкция по эксплуатации - Страница 28

Optimizing the speaker setting for your listening room

26

 En

This unit employs the YPAO (Yamaha Parametric Room Acoustic Optimizer) technology which lets you avoid 
troublesome listening-based speaker setup and achieves highly accurate sound adjustments automatically. The supplied 
optimizer microphone collects and this unit analyzes the sound your speakers produce in your actual listening 
environment.

• Be advised that it is normal for loud test tones to be output 

during the “AUTO SETUP” procedure.

• To achieve the best results, make sure the room is as quiet as 

possible while the “AUTO SETUP” procedure is in progress. If 
there is too much ambient noise, the results may not be 
satisfactory.

y

You can run “AUTO SETUP” using the system menu that appears 
in the OSD or in the front panel display. This manual uses the 
OSD illustrations to explain the “AUTO SETUP” procedure.

1

Make sure of the following check points.

Before starting the automatic setup, check the following 
check points.

❏

Speakers are connected appropriately.

❏

Headphones are disconnected from this unit.

❏

This unit and the video monitor are turned on.

❏

This unit is selected as the video input source of 
the video monitor.

❏

The connected subwoofer is turned on and the 
volume level is set to about half way (or slightly 
less).

❏

The crossover frequency controls of the 
connected subwoofer is set to the maximum.

❏

FRONT A speakers are selected as the front 
speaker system (see page 35).

❏

The room is sufficiently quiet.

2

Connect the supplied optimizer microphone 
to the OPTIMIZER MIC jack on the front 
panel.

The following display appears in the OSD.

3

Place the optimizer microphone at your 
normal listening position on a flat level 
surface with the microphone heading 
upward.

y

It is recommended that you use a tripod (etc.) to affix the 
optimizer microphone at the same height as your ears would be 
when you are seated in your listening position. You can use the 
attached screw of a tripod (etc.) to fix the optimizer microphone 
to the tripod (etc.).

Optimizing the speaker setting for your listening room

Using AUTO SETUP

Notes

Note

VOLUME

MIN

MAX

MIN

MAX

CROSSOVER 

HIGH CUT

Controls of a subwoofer (example)

O/MAN'L

ZONE

CONTROL

OPTIMIZER MIC

AUDIO SELECT

VIDEO

L    AUDIO    R

VIDEO AUX

USB

Optimizer 
microphone

AUTO SETUP

SETUP

;;;;;;;

AUTO

.

START

Automatic

Processing

of all item

[ ]/[ ]:Up/Down

[ENTER]:Start

p

p

Optimizer microphone