DeLonghi EN510.B - Инструкция по эксплуатации - Страница 28

27

EN

Troubleshooting

No light indicator.

- Check the mains, plug, voltage, and fuse. In case of problems, call the 

Nespresso

 Club.

No coffee, no water.

- Water tank is empty. Fill water tank.

- Descale if necessary; see Descaling section.

Coffee comes out very slowly.

- Flow speed depends on the coffee variety.

- Descale if necessary; see Descaling section.

No coffee, just water runs out (despite inserted capsule).

- Make sure the capsule is not pinched in a wrong position.

- Make sure the capsule is not damaged.

- Call 

Nespresso

 Club or send appliance to repair.

Coffee is not hot enough.

- Preheat cup.

- Descale if necessary; see Descaling section.

Capsule area is leaking (water in capsule container).

- Position capsule correctly. If leakages occur, call the 

Nespresso

 Club.

Any other blinking behavior not described in the troubleshooting.

- Send appliance to repair or call the 

Nespresso

 Club.

All buttons blink simultaneously for 10 seconds and then machine switches off 

automatically.

- Error alarm, machine needs repair. Send appliance to repair or call the 

Nespresso

 Club.

All 3 buttons blinking fast 3 times and then machine goes back in ready mode.

- Water tank is empty.

Descaling and cleaning alert blink.

- Machine is in menu mode, press milk button for 3 seconds to exit menu mode or wait 30 seconds to exit automatically.

Descaling alert blinks orange.  

- Machine triggers descaling alert according beverages consumption usage. Descale machine.

Descaling alert blinks orange and Espresso button illuminates white.

- Machine is in descaling mode. Press Espresso button to start descaling process.

Descaling alert illuminates orange, beverage buttons are unavailable.

-  Machine blocked due to scale level too high. Descale machine.

All coffee buttons and all milk recipe buttons flash alternatively.

- Machine in overheat protection mode, wait until it returns to ready mode.

- Appliance will be blocked for approximately 10 minutes after emptying.

Lever cannot be closed completely.

- Empty capsule container. Make sure that no capsule is blocked inside the capsule container.

Quality of Milk froth is not up to standard.

- Use skimmed or semi-skimmed cow milk at refrigerator temperature (about 4° C). 

- Rinse after each milk preparation (see section "Hand Washing of Rapid Cappuccino System").

- Descale the machine.

- Do not use frozen milk.

- Ensure the air aspiration part is clean. Refer to the section "Hand washing of Rapid Cappuccino System".

I cannot enter Menu mode.

- Be sure to remove the milk jug.

- Be sure to press milk button for 3 seconds.

- Remove descaling pipe.

- Is not possible to enter Menu mode while machine is heating up.

Milk dispensing doesn't start (clean alert illuminates orange).

- Prepared more than 5 milk dispensing without any cleaning. Action: clean Rapid Cappuccino System.

- Overtime milk preparation. Action: clean Rapid Cappuccino System.

- Over 30 min from last milk preparation. Action: clean Rapid Cappuccino System.

Milk jug cannot be dismantled.

- Press the button on the side of the milk jug to remove the parts.

- Refer to section "Assembling / Disassembling of Rapid Cappuccino System".

Sound when machine switches off.

- This sound indicates that the machine is now off.

In the event of accidental milk spillage, unplug the machine.

- Immediately clean thoroughly the machine.