Sparky TV 1835 - Инструкция по эксплуатации - Страница 15

13

Original instructions

EN

has to be done by the manufacturer or his agent in order 

to avoid a safety hazard.

BRUSH REPLACEMENT

When  the  carbon  brushes  are  worn  out,  both  brushes 

must be replaced simultaneously with genuine brushes 

at  SPARKY  service  centre  for  warranty  and  post-war-

ranty service.

CLEANING

For safe operation always keep the machine and its ven-

tilation slots clean.

Regularly check to see if any dust or foreign matter has 

entered  the  ventilation  slots  and  the  grills  around  the 

switches. Use a soft brush and/or air jet to remove any 

accumulated dust. Wear safety glasses to protect your 

eyes whilst cleaning.

Exterior plastic parts may be cleaned with a damp cloth 

and mild detergent if necessary.

WARNING:

 Never use alcohol, petrol or other 

cleaning  agent.  Never  use  caustic  agents  to  clean 

plastic parts.

WARNING: 

Water must never come into con-

tact with the tool.

IMPORTANT!

  To  assure  product  safety  and  reliability, 

repairs,  maintenance  and  adjustment  (including  brush 

inspection and replacement) should be performed by 

SPARKY  certified  service  centres,  always  using  genu-

ine replacement parts.

Warranty

The guarantee period for SPARKY power tools is deter

-

mined in the guarantee card.

Faults due to normal wear, overloading or improper han-

dling will be excluded from the guarantee.

Faults due to defective materials implemented as well as 

defects in workmanship will be corrected free of charge 

through replacement or repair.

The  complaints  for  defective  SPARKY  power  tools  will 

be recognized if the machine is sent back to the dealer 

or is presented to the authorised warranty service centre 

undismantled, in its initial condition.

Notes

Carefully read the entire Original Instructions before us

-

ing this product.

The  manufacturer  reserves  the  right  to  make  changes 

and improvements to the products and to alter specifica-

tions without prior notice.

Specifications may differ from country to country.

TROUBLESHOOTING

Problem

Probable cause

Corrective action

Motor does not run.

No supply power.

Check the power supply, connect the 

machine to another power outlet.

Faulty cable or plug .

Take the machine to an authorized service 

centre.

Worn carbon brushes.

Take the machine to an authorized service 

centre.

Other electrical fault.

Take the machine to an authorized service 

centre.

Chain saw does not operate at full 

capacity.

. Extension cord is too long or its cross 

section is too small.

Use an extension cord with proper length and 

cross section.

Power supply voltage (e.g. generator) is 

too low.

Connect the chain saw to another power 

outlet.

Poor cutting performance.

Improperly tensioned chain.

Tension the chain properly.

Worn-out (dull) chain.

Sharpen the chain or replace it.

Chain / guide bar overheats.

There is no oil in tank.

Refill oil.

Oil cap vents are clogged.

Clean the cap vents.

Oil passage clogged.

Clean oil passage outlet.

Chain is over-tensioned.

Tension chain properly.

Worn-out (dull) chain.

Sharpen the chain or replace it.

pages-TV-1835-2040-2245-2017.indd   13

11.5.2017 г.   14:42:52