Philips HR7766 - Инструкция по эксплуатации - Страница 17

troubleshooting

This chapter summarises the most common problems you could encounter with the appliance. If 

you are unable to solve the problem with the information below, contact the Consumer Care 

Centre in your countr y. 

Problem

Solution

The appliance does 

not go on when I turn 

the control knob to 

PULSE or to speed 1 

or 2. 

Make sure the food processor, blender jar, juicer or meat mincer is 

assembled properly (‘click’). If you are not using the food processor, the 

juicer or the meat mincer, make sure the screw cap is assembled 

correctly on the motor unit. If you are using the blender jar, make sure 

the rib on the blender jar is directly opposite the print on the motor 

housing. If you are using the food processor, make sure that the dots 

indicated on the bowl and lid are directly opposite each other and the 

dot on the bowl is directly opposite the dot on the motor unit. If all 

par ts are assembled correctly, the appliance star ts to operate when you 

turn the control knob to PULSE or to speed 1 or 2.

The 

appliance suddenly 

stops running.

The thermal safety cut-out has probably cut off the power supply to the 

appliance because the appliance has overheated. 1) Turn the control 

knob to O to switch off the appliance. Unplug the appliance. 2) Let the 

appliance cool down for 1 hour. 3) Put the mains plug in the socket. 4) 

Switch on the appliance again.

Both the blender jar 

and the food 

processor bowl are 

attached, but only the 

blender works.

If both the blender and the food processor are assembled correctly onto 

the motor unit, only the blender works. If you want to use the food 

processor, remove the blender from the motor unit and screw the screw 

cap onto the motor unit.

The balloon beater or 

kneading accessor y 

does not turn.

Make sure the balloon beater or kneading accessor y is assembled 

properly onto the tool holder. Also make sure the food processor bowl 

and the lid are assembled properly (‘click’).

The meat looks as if it 

has been ‘pressed 

through’ rather than 

minced.

Make sure the cutting edges of the cutter unit point outwards.

The meat mincer does 

not work.

Make sure the gear housing and the cutter housing are assembled 

properly (‘click’).

I cannot place the 

cutter unit properly in 

the cutter housing.

Unscrew the screw ring a little and then place the cutter unit and the 

grinding disc properly onto the worm shaft. Then screw the screw ring 

properly onto the cutter housing.

The meat mincing 

result is too coarse.

You used the medium grinding disc. Use the fine one. Mince the meat 

again to get a finer result.

The metal par ts of the 

meat mincer look 

rusty.

You have probably cleaned these par ts in the dishwasher. You have to 

clean all par ts of the meat mincer by hand and dr y them immediately 

with a tea towel.

EnglisH

17