Makita PLM4631N2 - Инструкция по эксплуатации - Страница 18

18

10-3 BLADE MOUNTING TORQUE

Center bolt 40 Nm - 50 Nm, to insure safe operation of 
your unit. All nuts and bolts must be checked periodically 
for correct tightness.
After prolonged use, especially in sandy soil conditions, 
the blade will become worn and lose some of the original 
shape. Cutting efficiency will be reduced and the blade 
should be replaced. Replace with an approved factory 
replacement blade only. Possible damage resulting from 
blade unbalance condition is not the responsibility of the 
manufacturer.
When you change the blade, must use the original type 
marked on the blade (MAKITA 263001451 for 
PLM4630N2/PLM4631N2/PLM4632N, MAKITA 
263002552 for PLM5130N) (for order the blade, pls. 
contact your local dealer or call our company, see cover 
page).

10-4 ENGINE

Refer to the separate engine manual for engine 
maintenance instructions.
Maintain engine oil as instructed in the separate engine 
manual packed with your unit. Read and follow 
instructions carefully.
Service air cleaner as per separate engine manual under 
normal conditions.
Clean every few hours under extremely dusty conditions. 
Poor engine performance and flooding usually indicates 
that the air cleaner should be serviced.
To service the air cleaner, refer to the separate engine 
manual packed with your unit.
The spark plug should be cleaned and the gap reset once 
a season. Spark plug replacement is recommended at the 
start of each mowing season; check engine manual for 
correct plug type and gap specifications.
Clean the engine regularly with a cloth or brush. Keep the 
cooling system (blower housing area) clean to permit 
proper air circulation which is essential to engine 
performance and life. Be certain to remove all grass, dirt 
and combustible debris from muffler area.

11. STORAGE INSTRUCTIONS 

(OFF SEASON)

The following steps should be taken to prepare lawn 
mower for storage.
1. Empty the tank after the last mowing of the season.

a) Empty the petrol tank with a suction pump.

CAUTION:

 Do not drain the petrol in closed 

rooms, in close proximity of open fire, etc. Do not smoke! 
Petrol fumes can cause explosion or fire.

b) Start the engine and let it run until it has used up all 

remaining petrol and stalls.

c) Remove the spark plug. Use an oilcan to fill approx. 

20 ml oil into the combustion chamber. Operate the 
starter to evenly distribute the oil in the combustion 
chamber. Replace the spark plug.

2. Clean and grease the lawn mower carefully as 

described above under “LUBRICATION 
INSTRUCTIONS”.

3. Slightly grease the cutter to avoid corrosion.
4. Store the lawn mower in a dry, clean and frost-

protected place, out of reach of unauthorized persons.

CAUTION:

 The engine must have completely 

cooled down before storing the lawn mower.

NOTE:

- When storing any type of power equipment in an 

unventilated or material storage shed.

- Care should be taken to rust-proof the equipment. 

Using a light oil or silicone, coat the equipment, 
especially cables and all moving parts.

- Be careful not to bend or kink cables.
- If the starter rope becomes disconnected from rope 

guide on handle, disconnect and ground the spark plug 
wire, depress the blade control handle and pull the 
starter rope out from engine slowly. Slip the starter rope 
into the rope guide bolt on handle.

Transport

Turn the engine off and allow the engine to cool down. 
Then disconnect the spark plug wire and empty the fuel 
tank according to the instructions in the engine manual. 
Ensure not to bend or damage the cutter when pushing 
the lawn mower over obstacles.