Makita PLM4631N2 - Инструкция по эксплуатации - Страница 16

16

7-3 OPERATION PROCEDURES

During operation, tightly hold the brake handle with both 
hands.

NOTE:

  During operation, when the brake handle 

is released, the engine will stop and thus stopping the 
lawn mower from operating.

WARNING:

 In order to avoid any unintentional 

start-ups of the lawn mower, it comes equipped with an 
engine brake which must be pulled back before the 
engine can be started. When the engine control lever is 
released it must return to its initial position, at which point 
the engine automatically switches off.

NOTE:

 Engine brake (brake handle): Use the 

lever to stop the engine. When you release the lever the 
engine and the blade stop automatically. To mow, hold the 
lever in the working position. Before you start to mow, 
check the start/stop lever several times to be sure that it is 
working properly. Ensure that the tension cable can be 
smoothly operated (i.e. is not catching or kinking in any 
way).

7-4 TO STOP ENGINE

CAUTION:

 The blade continues to rotate for a 

few seconds after the engine is shut off.
1. Release the brake control handle to stop the engine 

and blade. 

(Fig. 29)

2. Disconnect and ground the spark plug wire as 

instructed in the separate engine manual to prevent 
accidental starting while equipment is unattended.

7-5 CONNECTION FOR AUTO MOVE

For PLM4631N2

Grip the self-drive control handle, the lawn mower will 
move forward automatically with about 3.6 km/h 

(Fig. 30)

, 

release the self-drive handle, the lawn mower will stop 
move. 

For PLM4632N, PLM5130N

The mower is equipped with a speed adjusting system 
which can adjust 3 speeds from 3.0 km/h to 4.5 km/h.
Position “

”: the slowest position; Position “

”: the 

fastest position. 

(Fig. 31)

The step as below:
1. Release the self-drive control handle until the lawn 

mower does not go forward.

2. Adjust the appropriate speed which you want. 

(Fig. 31)

3. Grasp the self-drive control handle to go on mowing. 

(Fig. 30)

CAUTION:

 Your mower is designed to cut normal 

residential grass of a height no more than 250 mm. 
Do not attempt to mow through unusually tall dry or wet 
grass (e.g., pasture) or piles of dry leaves. Debris may 

build up on the mower deck or contact the engine exhaust 
presenting a potential fire hazard.

7-6 FOR THE BEST RESULTS WHEN 

MOWING

Clear lawn of debris. Be sure that the lawn is clear of 
stones, sticks, wire or other foreign objects which could be 
accidentally thrown out by the mower in any direction and 
cause serious personal injury to the operator and others 
as well as damage to property and surrounding objects. 
Do not cut wet grass. For effective mowing do not cut wet 
grass because it tends to stick to the underside of the 
deck preventing proper mowing of the grass clippings. Cut 
no more than 1/3 the length of the grass. The 
recommended cut for mowing is 1/3 the length of the 
grass. Ground speed will need to be adjusted so the 
clippings can be dispersed evenly into the lawn. For 
especially heavy cutting in thick grass it may be 
necessary to use one of the slowest speeds in order to get 
a clean well mowed cut. When mowing long grass you 
may have to cut the lawn in two passes, lowering the 
blade another 1/3 of the length for the second cut and 
perhaps cutting in a different pattern than was used the 
first time. Overlapping the cut a little on each pass will 
also help to clean up any stray clippings left on the lawn. 
The mower should always be operated at full throttle to 
get the best cut and allow it to do the most effective job of 
mowing. Clean underside of deck. Be certain to clean the 
underside of the cutting deck after each use to avoid a 
build-up of grass, which would prevent proper mulching. 
Mowing leaves. The mowing of leaves can also be 
beneficial to your lawn. When mowing leaves make sure 
they are dry and are not laying too thick on the lawn. Do 
not wait for all the leaves to be off the trees before you 
mow.

WARNING:

 If you strike a foreign object, stop the 

engine. Remove wire from spark plug, thoroughly inspect 
the mower for any damage and repair the damage before 
restarting and operating the mower. Extensive vibration of 
the mower during operation is an indication of damage. 
The unit should be promptly inspected and repaired.

7-7 GRASS CATCHER

There is a level indicator on the top of the grass catcher 
that shows whether the catcher is empty or full 

(Fig. 32, 

Fig. 33)

:

- The level indicator inflates if the catcher is not full 

during the moving. 

(Fig. 33)

- If the catcher is full, the indicator collapses; once this 

happens, stop moving immediately and empty the 
catcher, make sure it is clean and ensure its meshwork 
is ventilated. 

(Fig. 32)

IMPORTANT

If the position of indicator opening is very dirty, the 
indicator will not inflate-in this case, clean the position of 
indicator opening immediately.