Electrolux OPEB 2500 R (V) - Инструкция по эксплуатации - Страница 22

Step 8

Clean the glass panels with water and soap.

Dry the glass panels carefully. Do not clean

the glass panels in the dishwasher.

Step 9

After cleaning, install the glass panel and the

oven door.

The screen-printing zone must face the inner side of

the door. Make sure that after the installation the sur‐

face of the glass panel frame on the screen-printing

zones is not rough when you touch it.

When installed correctly the door trim clicks.

Make sure that you install the internal glass panel in

the seats correctly.

A

11.4 How to replace: Lamp

WARNING!

Risk of electric shock.

The lamp can be hot.

Always hold the halogen lamp with a cloth to

prevent grease residue from burning on the

lamp.

Before you replace the lamp:

Step 1

Step 2

Step 3

Turn off the oven. Wait until the

oven is cold.

Disconnect the oven from the

mains.

Put a cloth on the bottom of the cav‐

ity.

Back lamp

Step 1

Turn the glass cover to remove it.

Step 2

Clean the glass cover.

Step 3

Replace the lamp with a suitable 300 °C heat-resistant lamp.

Step 4

Install the glass cover.

12. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

12.1 What to do if...

In any cases not included in this table please

contact with an Authorised Service Centre.

Problem

Check if...

The oven does not heat

up.

The fuse is blown.

The door gasket is dam‐

aged.

Do not use the oven.

Contact an Authorised

Service Centre.

22

ENGLISH