Daikin FWT-CT - Инструкция по эксплуатации - Страница 5

1-3

English

INSTALLATION MANUAL

This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit.
Special adjustment may be necessary to suit local requirements.
Before using your air conditioner, please read this instruction manual carefully and keep it for future reference. This appliance is 
intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay persons.
This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, or 
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a 
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.

SAFETY PRECAUTIONS

!

 WARNING

!

 CAUTION

 Installation and maintenance should be performed by qualified 
persons who are familiar with local code and regulation, and 
experienced with this type of appliance.
 All field wiring must be installed in accordance with the 
national wiring regulation.
 Ensure that the rated voltage of the unit corresponds to that 
of the name plate before commencing wiring work according 
to the wiring diagram.
 The unit must be GROUNDED to prevent possible hazard 
due to insulation failure.
 All electrical wiring must not touch the refrigerant piping, or 
any moving parts of the fan motors.
 Confirm that the unit has been switched OFF before installing 
or servicing the unit.
 Disconnect from the main power supply before servicing the 
air conditioner unit.
 DO NOT pull out the power cord when the power is ON. 
This may cause serious electrical shocks which may result 
in fire hazards.
 Keep the indoor and outdoor units, power cable and 
transmission wiring, at least 1m from TVs and radios, to 
prevent distorted pictures and static. {Depending on the type 
and source of the electrical waves, static may be heard even 
when more than 1m away}.

•

•

•

•

•

•

•

•

•

Please take note of the following important points when 
installing.

 Ensure that the drainage piping is connected properly. 

If the drainage piping is not connected properly, it 
may cause water leakage which will dampen the 
furniture.

 Ensure that the unit’s panel is closed after service or 
installation.

Unsecured panels will cause the unit to operate 
noisily.

 Sharp edges and coil surfaces are potential locations which 
may cause injury hazards.
Avoid from being in contact with these places.
 Before turning off the power supply, set the remote 
controller’s ON/OFF switch to the “OFF” position to 
prevent the nuisance tripping of the unit. 

If this is not done, 

the unit’s fans will start turning automatically when power 
resumes, posing a hazard to service personnel or the user.

Do not install the units at or near doorway.
 Do not operate any heating apparatus too close to the 
air conditioner unit or use in room where mineral oil, oil 
vapour or oil steam exist, this may cause plastic part to 
melt or deform as a result of excessive heat or chemical 
reaction.
 When the unit is used in kitchen, keep flour away from 
going into suction of the unit.
 This unit is not suitable for factory used where cutting oil 
mist or iron powder exist or voltage fluctuates greatly.
 Do not install the units at area like hot spring or oil refinery 
plant where sulphide gas exists.
 Ensure the color of wires of the outdoor unit and the 
terminal markings are same to the indoors respectively.
 IMPORTANT : DO NOT INSTALL OR USE THE AIR 
CONDITIONER UNIT IN A LAUNDRY ROOM.
 Don't use joined and twisted wires for incoming power 
supply.
 The equipment is not intended for use in a potentially 
explosive atmosphere.

•

•

•

•

•
•

•

•

•

•

•

•

•

NOTICE

Disposal requirement

Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall not be 
mixed with unsorted household waste.
Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the refrigerant, of 
oil and of other parts must be done by a qualified installer in accordance with relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By ensuring this product 
is disposed of correctly, you will help to prevent potential negative consequences for the environment and human health. 
Please contact the installer or local authority for more information.
Batteries must be removed from the remote controller and disposed of separately in accordance with relevant local and 
national legislation.

1 IM-WMJW-0312(0)DKdenv_EN.indd   3

1 IM-WMJW-0312(0)DKdenv_EN.indd   3

5/21/12   9:21:47 AM

5/21/12   9:21:47 AM