Daikin FWT-CT - Инструкция по эксплуатации - Страница 11

1-9

English

1. Open the front panel. 

  •  Hold the panel at the recesses on the main unit 

(2 recesses on right and left sides) and lift it until it 
stops.

3. Clean or replace each 

fi

 lter.

  •  When shaking off remaining water, do not wring the 

fi

 lter.

4. Set the air 

fi

 lter as they were and close the front 

panel.

  •  Insert claws of the 

fi

 lters into slots of the front panel. 

Close the front panel slowly and push the panel at the 
3 points. (1 on each side and 1 in the middle.)

 • The 

air 

fi

 lter have a symmetrical form in the horizontal 

direction.

2. Pull out the air 

fi

 lters.

  •  Push a little upwards the tab at the center of each air 

fi

 lter, then pull it down.

Recess on  
main unit

AIR FILTER

SERVICE AND  MAINTENANCE

Service Parts

Maintenance Procedures

Indoor air 

fi

 lter

 Remove any dust adhering to the 

fi

 lter by using a vacuum cleaner or wash in lukewarm 

water (below 40°C/104°F) with a neutral cleaning detergent.
Rinse the 

fi

 lter well and dry before placing it back onto the unit.

Do not use gasoline, volatile substances or chemicals to clean the 

fi

 lter.

1.

2.
3.

Indoor unit

 Clean any dirt or dust on the grille or panel by wiping it with a soft cloth soaked in 
lukewarm water (below 40°C/104°F) and a neutral detergent solution.
Do not use gasoline, volatile substances or chemicals to clean the indoor unit.

1.

2.

FRONT

Rotating 

shaft

Recess on 

main unit

!

 CAUTION

•  Don’t touch the metal parts of the indoor unit. It may cause an injury.
•  When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
•  For cleansing, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing 

compound, scrubbing brushes, nor other hand stuff.

•  After cleaning, make sure that the front panel is securely 

fi

 xed.

1. Open the front panel.

  •  Hold the panel at the recesses on the main unit (2 recesses 

on right and left sides) and lift it until it stops.

2. Remove the front panel.

  •  While lifting the front panel further, slide it to the right 

and pull it to the front side. The left rotating shaft is 
detached. Slide the right rotating shaft to the left and 
pull it to the front side to remove it.

3. Attach the front panel.

  •  Align the right and left rotating shafts of the front panel 

with the grooves and push them all the way in.

  •  Gently close the front panel. (Push both ends and the 

center on the front panel.)

1 IM-WMJW-0312(0)DKdenv_EN.indd   9

1 IM-WMJW-0312(0)DKdenv_EN.indd   9

5/21/12   9:21:49 AM

5/21/12   9:21:49 AM