Oleo-Mac GST 250 5029-9001E2T - Инструкция по эксплуатации - Страница 30

26

I

GB

F

D

E

SK

P

GR

TR

CZ

RUS

UK

PL

be pulled upwards a few millimetres (Fig. 10).

WARNING - Always maintain the correct 

chain tension. An excessively slack chain 

increases the risk of kickback and the chain may 
ride out of the bar channel; these events can 
cause injury the operator and damage to the 
chain. An excessively slack chain will result in 
rapid wear of chain, bar and sprocket. On the 
contrary, an over tensioned chain will tend to 
overload the motor with resulting damage. A 

correctly tensioned chain provides the best 

cutting characteristics, optimal safety, and 

long working life of the chain. The working life 
of the chain depends on correct tensioning and 
correct lubrication.

5. STARTING

FUELING

WARNING: G asoline is an ex tremely 

flammable fuel. Use extreme caution 

when handling gasoline or fuel mix. Do not 

smoke or bring any fire or flame near the fuel 

or the chainsaw.

 · To reduce the risk of fire and burn injur y, 

handle fuel with care.  It is highly flammable.

 · Mix and store fuel in a container approved for 

gasoline.

 · Mix fuel outdoors where there are no sparks or 

flames.

 · Select bare ground, stop engine, and allow to 

cool before refueling.

 · Loosen fuel cap slowly to release pressure and 

to keep fuel from escaping around the cap.

 · Tighten fuel cap securely after refueling. Unit 

vibration can cause an improperly tightened 
fuel cap to loosen or come off and spill 
quantities of fuel.

 · Wipe spilled fuel from the unit. Move 3 metre 

away from refueling site before star ting 
engine.

 · Never attempt to burn off spilled fuel under 

any circumstances.

 · Do not smoke while handling fuel or while 

operating the chainsaw.

 · Store fuel in a cool, dry, well ventilated place.
 · Never place the mitblower in a combustible 

area such as dry leaves, straw, paper, etc.

 · Store the unit and fuel in an area where fuel 

vapors cannot reach sparks or open flames 
from water heaters, electric motors or switches, 
furnaces, etc.

 · Never take the cap off the tank when the 

engine is running.

 · Never use fuel for cleaning operations.
 · Take care not to get fuel on your clothing.

This product is powered by a 2-cycle engine and 
requires pre-mixing gasoline and 2-cycle oil.  
Pre-mix unleaded gasoline and 2-cycle engine oil 
in a clean container approved for gasoline.

R E CO M M E N D E D   F U E L :  T H I S   E N G I N E   I S 
CERTIFIED TO OPERATE ON UNLEADED GASOLINE 
INTENDED FOR AUTOMOTIVE USE WITH AN 
OCTANE RATING OF 89 ([R + M] / 2) OR HIGHER.
Mix 2-cycle engine oil with gasoline according to 
the instructions on the package.
We strongly recommend the use of 2% (1:50) 
Oleo-Mac/Efco two cycle engine oil, which is 
s p e c i f i c a l l y   f o r m u l a t e d   f o r   a l l   a i r - c o o l e d 
two-stroke engines.
The correct oil / fuel proportions shown in the 
table are suitable when using the Oleo-Mac/Efco 

PROSINT 2 and EUROSINT 2 or an equivalent 
high-quality engine oil (JASO specification FD 

or ISO specification L-EGD).

GASOLINE

OIL

2% - 50:1

ℓ

ℓ

(cm

3

)

1

5

10

15

20

25

0,02

0,10

0,20

0,30

0,40

0,50

(20)

(100)

(200)

(300)

(400)

(500)

  CAUTION: DO NOT USE AUTOMOTIVE OIL 

OR 2-CYCLE OUTBOARD OIL.

 CAUTION:

-  Match your fuel purchases to your 

consumption; don’t buy more than you 

will use in one or two  months;