Siemens TK 76K573 - Инструкция по эксплуатации - Страница 54

52

de

en

Place container under milk frother  

» 

Start

Place a container with a capacity of 

0�5 litres under the milk frother (10)� 

Press 

start stop

 (8)�

  The coffee grounds container (26) 

can also be used� To avoid splut-

tering, push the coffee outlet (9) 

down fully�

  If the water filter is activated, the 

following message is displayed:  

Remove filter 

» 

Start 

Remove the water filter and press 

start stop

 (8)�

Add 0.5 l water and descaler 

» 

Start

Pour lukewarm water into the empty 

water tank (12) up to the 

calc

 (0�5 litre) 

mark and dissolve two descaling tablets 

in it� Press 

start stop

 (8)�  

The descaling programme now runs for 

about 24 minutes:

Descaling

  If there is not enough descaling 

fluid in the water tank, the follow

-

ing message is displayed:

Not enough descaling fluid

Refill fluid 

Pour lukewarm water into the empty 

water tank (12) up to the 

calc

 (0�5 litre) 

mark and dissolve two descaling tablets 

in it� Press 

start stop

 (8)� The des-

caling programme will continue�

Clean and refill water tank 

» 

Start

Rinse the water tank and refill it with fresh 

water up to the “max” mark�

Press 

start stop

 (8)�  

The  descaling programme will now run 

for about 1 minute:

Descaling

Empty drip tray 

Empty the drip tray�

Replace drip tray

Replace the drip tray�

Replace the filter if one is being used. 

The appliance is ready for use again� 

Important: 

Wipe down the appli-

ance using a soft, damp cloth to 

immediately remove any descaler 

residue� Such residue can cause 

corrosion� New sponge cloths may 

contain salts� Salts can cause rust 

film on stainless steel and must 

therefore be washed out thor-

oughly before use�

Cleaning

If the prompt 

Service - clean

 is displayed, 

press and hold down 

i 

(7) for at least 

three seconds� The display shows:

Please press ‘Start/Stop’ to begin...

Cleaning program

or

To start without the prompt (see “Displaying 

Settings”) press and hold down 

i 

(7) for 

at least three seconds and select

Please press ‘Start/Stop’ to begin...

Cleaning program

Press

start stop

 (8)� The display 

will guide you through the programme�

Empty drip tray

Empty the drip tray (20)�

Replace drip tray

Replace the drip tray�

Cleaning

Open drawer

Deploy the appliance and open the 

drawer (17)�

Insert cleaning tablet! 

Close drawer!

Drop a cleaning tablet in the drawer and 

close the drawer again�  

The cleaning programme will now run 

for about 1 minute�