Zelmer 616 - Инструкция по эксплуатации - Страница 126

126

Exhaust air 

fi

 lter

The exhaust air 

fi

 lter should be replaced upon about 30 hours of operation 

(6 months) or earlier in case it gets very dirty.

Press the blockade and open the exhaust cover.

–

Replace the 

fi

 lter 

–

(1 and 2):

FILTER REPLACEMENT

In the course of the operation the inlet and exhaust air 

fi

 lters get dirty. To ensure proper operation of the 

vacuum cleaner it is recommended to rinse the inlet 

fi

 lter frequently. A very dirty or damaged inlet 

fi

 lter has 

to be replaced with a new one.

Inlet 

fi

 lter

Model: 616.*E – Fig.A – Electro

fi

 lter

Position the new 

fi

 lter thoroughly so that the frame edges stick tightly to 

the rim of the 

fi

 lter.

M

odel: 616.*S – Fig.B – HEPA Filter cartridge

Upon going though the turbines this foam condenses then on the exhaust 

fi

 lter. To avoid this you 

should add an anti-foam agent recommended by ZELMER S.A. to the front container and to turn on 
the vacuum cleaner (without the front container) for a few minutes to let the suction system dry.
The exhaust air 

fi

 lter shall always be replaced with a genuine brand-new one.

Open the upper cover and set it to a vertical position.

–

Seize the top edge of the 

fi

 lter with your 

fi

 ngers and pull it slightly towards you until 

–

it pulls out from the clamps.
Rotate the frame, take the 

fi

 lter out, rinse it with running water wringing it out slightly, 

–

dry it and set in place (or replace with a new one).
Position the new 

fi

 lter thoroughly so that the frame edges stick tightly to the rim of 

–

the 

fi

 lter.

Close the cover.

–

instrukcja 616-010.indb   126

instrukcja 616-010.indb   126

2008-09-18   16:03:21

2008-09-18   16:03:21