La Cornue CornuFe 110 F1 - Инструкция по эксплуатации - Страница 38

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

34

Range operational checks

Oven check

Turn on the oven and check that the oven fans start to turn 

and that the oven starts to heat up. Turn off the oven. 

Oven light

Press the oven light switch and check that the lights are 

working. 

NOTE:

 The oven light bulbs are not included in the warranty. 

Check ignition of cooktop burners

Operation of all cooktop burners should be checked after the 

range and gas supply lines have been carefully checked for 

leaks. 
There is a flame safety device that stops the flow of gas to 

the burner if the flame goes out. There is also a spark ignition 

system that works when the knob is pressed in. 
For each burner, push in and turn a knob to the lighting 

position. 
Keep holding the knob pressed in to let the gas through to 

the burner for a few seconds. 
If, when you let go of the control knob, the burner goes out, 

the safety device has not held in. Turn the control to the 

off position and wait one minute, then try again this time 

holding in the control knob for slightly longer. 

Quality of flames

If the flame is distorted, check that the burner head is 

correctly placed over the burner base. 



MAKE SURE THE FLOW OF COMBUSTION AND 

VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED. 



MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF 

POSITION. 

Customer care

Please complete your details in the table at the end of the 

‘Using your Range’ section of this guide. 
Place these instructions into the colored CornuFé folder in the 

instruction pack and hand them to the user. 
Thank you. 

How to move the range for 
servicing

Follow these procedures to remove appliance for servicing:

• 

Shut off the gas supply and turn off the circuit breaker. 

• 

Disconnect gas supply tubing to appliance and unplug 

the electrical supply cord. 

NOTE:

 A suitably qualified person should disconnect and 

reconnect the gas supply. 
Take great care. We recommend two people maneuver the 

range. Make sure that the floor covering is firmly attached, 

or removed to prevent it being disturbed when moving the 

range around. 
Before attempting to move the range, see 

“Moving the 

range”

. 

Replacing the range

Reverse procedure to reinstall. If the gas line has been 

disconnected, check for gas leaks after reconnection. 

NOTE:

 A suitably qualified person should disconnect and 

reconnect the gas supply. 
The service engineer 

MUST

 follow installation instructions 

provided with the gas appliance connector and the warning 

label attached to the connector. 
Failure to take this precaution could result in tipping of the 

range and cause injury. 
Replace the storage drawer and door.