Bosch MUM 58C10 - Инструкция по эксплуатации - Страница 22

22 

en

Operation 

Important information concerning the 

use of the whisk (Figure 

E

):

The whisk should almost touch the bottom 

of the bowl to ensure that the ingredients 

are optimally mixed. If not, adjust the height 

of the whisk as follows:

■

Remove mains plug.

■

Press the Release button and 

move the swivel arm to 

position 

2

.

■

Insert the whisk into the drive 

until the whisk locks into position.

■

Hold whisk in place and loosen nut clock­

wise using open­ended wrench (size 8).

■

Set the whisk to the optimum height by 

rotating the whisk: 

– Turn clockwise: Raise 

– Turn anti­clockwise: Lower

■

Press the Release button and  

move the swivel arm to 

position 

1

. 

■

Check the height of the whisk 

and, if required, correct.

■

When the height has been set  

correctly, press Release button 

and move the swivel arm to 

position 

2

.

■

Hold whisk in place and tighten nut 

anticlockwise using open­ended wrench 

(size 8).

Working with the bowl and the tools

Fig. 

F

:

■

Press the Release button and 

move the swivel arm to 

position 

2

.

■

Insert the bowl: 

Tilt the bowl forwards and then set it 

down. Turn anti­clockwise until it locks 

into place.

■

Depending on the processing task, insert 

the stirrer, whisk or kneading hook until it 

locks into position.

Note:

If using the kneading hook, rotate the dough 

deflector until the kneading hook can lock 

into position 

(Fig. 

F

-4b)

.

■

Put the ingredients to be processed into 

the bowl.

■

Press the Release button and move the 

swivel arm to position 

1

.

■

Attach the cover.

■

Set the rotary switch to the desired 

setting.

Our recommendation:

–

Professional flexi stirring whisk:

First mix at setting 1­2, then setting 

3­5 as required

–

Professional beating whisk:

setting 7, mix in at setting 1

–

Kneading hook:

first stir in at setting 1, knead at setting 3

Adding more ingredients

■

Switch off the appliance with the rotary 

switch.

■

Add more ingredients through the feed 

tube in the cover.

or

■

Remove lid.

■

Press the Release button and 

move the swivel arm to 

position 

2

.

■

Add ingredients.

After using the appliance

■

Switch off the appliance with the rotary 

switch.

■

Remove mains plug.

■

Remove lid.

■

Press the Release button and 

move the swivel arm to 

position 

2

.

■

Take the tool out of the drive.

■

Remove the bowl.

■

Clean all parts, see “Cleaning and 

servicing”.

Continuous-feed shredder

W

Risk of injury

Do not grip the sharp blades or edges of the 

cutting discs. Take hold of cutting discs by 

the edge only. Before attaching / removing 

the continuousfeed shredder, wait until the 

drive has come to a standstill and pull out 

the mains plug. Do not reach into the feed 

tube.