Ardesto ACM-12P-R290 - Инструкция по эксплуатации - Страница 137

137

EN

TIPS FOR USING REMOTE CONTROL

CAUTIONS FOR USING REMOTE CONTROL

•

The remote control must be used within 8

meters of the unit.

The unit will beep when remote signal is

received.

Curtains, other materials and direct sunlight

can interfere with the infrared signal receiver.

Remove batteries if the remote will not be

used more than 2 months.

• 

• 

• 

• 

• 

Inserting and Replacing Batteries

Your air conditioning unit may come with two

batteries(some units). Put the batteries in the 

remote control before use.  

1.

 Slide the back cover from the remote control

downward, exposing the battery compartment.

 Insert the batteries, paying attention to match

up the (+) and (-) ends of the batteries with

the symbols inside the battery compartment.

 Slide the battery cover back into place.

2.

3. 

 BATTERY NOTES

For optimum product performance:

•

Do not mix old and new batteries, or

batteries of different types.

•

Do not leave batteries in the remote control

if you don’t plan on using the device for more

than 2 months.

 BATTERY DISPOSAL 

Do not dispose of batteries as unsorted 

municipal waste. Refer to local laws for proper 

disposal of batteries.

The device could comply with the local national 

regulations. 

    In Canada, it should comply with 

    CAN ICES-3(B)/NMB-3(B). 

    In USA, this device complies with part 15 of the 

    FCC Rules. Operation is subject to the following 

    two conditions: 

(1) This device may not cause harmful interference,

and

(2) this device must accept any interference

received, including interference that may

cause undesired operation.

This equipment has been tested and found to 

comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection 

against harmful interference in a residential 

installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not 

installed and used in accordance with the 

instructions, may cause harmful interference to 

radio communications. However, there is no 

guarantee that interference will not occur in a 

particular installation. If this equipment does cause 

harmful interference to radio or television reception, 

which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct 

the interference by one or more of the following

measures: 

   Reorient or relocate the receiving antenna.

   Increase the separation between the equipment 

   and receiver.

   Connect the equipment into an outlet on a circuit 

   different from that to which the receiver is 

   connected.

   Consult the dealer or an experienced radio/TV 

   technician for help.

   Changes or modifications not expressly approved 

   by the party responsible for compliance could 

   void user’s authority to operate the equipment. 

03

Handling the Remote Controller

BATTERY NOTES

For optimum product performance:

•  Do not mix old and new batteries, or batteries of different types.

•  Do not leave batteries in the remote control if you don’t plan on using the 

device for more than 2 months.

BATTERY DISPOSAL

•  Do not dispose of batteries as unsorted municipal waste. Refer to local 

laws for proper disposal of batteries.

TIPS FOR USING REMOTE CONTROL

•  The remote control must be used within 8 meters of the unit.

•  The unit will beep when remote signal is received.

•  Curtains, other materials and direct sunlight can interfere with the 

infrared signal receiver.

•  Remove batteries if the remote will not be used more than 2 months.

•  When there are wide differences between remote controller manual 

and conditioner user manual on function description, the description of 

conditioner user manual shall prevail.

HANDLING THE REMOTE CONTROL

Inserting and Replacing Batteries

Your air conditioning unit may come with two batteries (some units). Put the 

batteries in the remote control before use.

1.  Slide the back cover from the remote control downward, exposing the 

battery compartment.

2.  Insert the batteries, paying attention to match up the (+) and (-) ends of the 

batteries with the symbols inside the battery compartment.

3.  Slide the battery cover back into place.