Веб-камеры Vaddio (999-99950) - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Troubleshooting and Care
When the camera doesn't behave as you expect, check the indicator light on the front before you do
anything else.
Use this table to determine whether it's time to call Vaddio Technical Support.
Power and Control
What is it doing?
Possible causes
Check and correct
Nothing.
The light on the front is off and
no video is available.
At least one of the cables is
bad.
Check using known good cables.
The wall outlet is not active.
(Check by finding out if it
powers something else, such
as a laptop or phone charger.)
Use a different outlet.
The camera or its power supply
is bad.
Contact your reseller or Vaddio
Technical Support.
The light on the front of the
camera is off but the web
interface and video are
available.
The status light is turned off.
You can turn it on again using the LED
On setting on the General tab of the
System page, or using the Telnet
command
camera led on
.
The camera is not responding
to the remote and the light is
yellow.
A firmware update is in
progress.
Wait a few minutes, and try again when
the light turns blue.
The camera does not respond
to the remote, but the web
interface is available.
The remote is not using the
same IR channel as the
camera.
Change the IR channel with the
Camera Select buttons on the remote.
The batteries in the remote are
dead.
Put new batteries in the remote.
The batteries were installed
incorrectly in the remote.
Install the batteries as shown in the
diagram inside the remote.
The camera responds to the
remote but the web interface is
not available.
The camera is not using the IP
address you browsed to.
Press the Data Screen button on the
remote to see camera information.
Video and Streaming
What is it doing?
Possible causes
Check and correct
No H.264 video stream.
IP streaming is not enabled.
Enable IP streaming: Streaming page in
the web interface.
Black and white video.
The IR cut filter is on. Send the
Telnet command
camera icr
get
to verify.
Send the Telnet command
camera
icr off
to turn off the IR cut filter and
return to normal video.
90
Complete Manual for the ConferenceSHOT AV Enterprise-Class Conferencing System
Характеристики
Остались вопросы?Не нашли свой ответ в руководстве или возникли другие проблемы? Задайте свой вопрос в форме ниже с подробным описанием вашей ситуации, чтобы другие люди и специалисты смогли дать на него ответ. Если вы знаете как решить проблему другого человека, пожалуйста, подскажите ему :)
