Yamaha RX-V2065 - Инструкция по эксплуатации - Страница 32

30

 En

Enjoying the sound field programs

In straight decode mode, sounds are reproduced without 
sound field effect. 2-channel stereo sources are output 
from only the front left and right speakers. Multi-channel 
input sources are decoded straight into the appropriate 
channels and multi-channel sounds are reproduced 
without a sound field effect.

1

To enable straight decode mode, press 

Q

STRAIGHT

 (or 

r

STRAIGHT

).

“Straight” appears on the front panel display.

2

To cancel straight decode mode, press 

Q

STRAIGHT

 (or 

r

STRAIGHT

) again.

A sound field program name appears on the front 
panel display, and sound is reproduced with that 
sound field effect.

Virtual CINEMA DSP allows you to enjoy DSP sound 
field surround effects even without any surround speakers 
by using virtual surround speakers. You can even enjoy 
Virtual CINEMA DSP using a minimal two-speaker 
system that does not include a center speaker. 
When “Surround Speaker” in the Setup menu is set to 
“None” (page 49), this unit operates in Virtual CINEMA 
DSP mode.

Note

•

Virtual CINEMA DSP is not available in the following conditions even if 
you set “Surround Speaker” to “None” (page 49).

–

headphone plug is connected to the PHONES jack.

–

7ch Stereo of the field sound program is selected.

–

Pure Direct mode or straight decode mode is used.

SILENT CINEMA allows you to enjoy multi-channel 
sources with your headphones. SILENT CINEMA mode 
is automatically selected when you connect the headphone 
plug to the PHONES jack.

Note

•

SILENT CINEMA mode is not available in the following conditions.

–

2ch Stereo of the sound field program is selected.

–

Pure Direct mode or straight decode mode is selected.

CINEMA DSP 3D mode creates the intensive and 
accurate stereoscopic sound field in the listening room.
To use this unit in CINEMA DSP 3D mode, presence 
speakers are required. Connect the presence speakers to 
the SP1 terminals, perform the following settings and then 
select a CINEMA DSP related sound field program.

•

Disconnect the headphones from the PHONES jack.

•

Set “Extra Speaker Assignment” to “Presence” 
(page 49).

•

Set “3D DSP” to “On” (page 55).

When the sound field program runs in CINEMA DSP 3D 
mode, the 3D indicator on the front panel display lights 
up.

Enjoying unprocessed input sources 
(Straight decode mode)

Enjoying sound field programs without 
surround speakers (Virtual CINEMA 
DSP)

Enjoy sound field programs with 
headphones (SILENT CINEMA™)

Using CINEMA DSP 3D mode