Yamaha RX-V465 - Инструкция по эксплуатации - Страница 21

19

 En

Optimizing the speaker setting for your listening room (YPAO)

English

INTR

ODUCTION

AD

DITIONAL 

INFORMA

T

ION

APPENDIX

PRE

P

ARA

T

ION

BA

S

IC

OPERA

T

ION

AD

V

ANCED

OPERA

T

ION

4

To select a sound character for adjustment, 
press 

n

Cursor

k

 to select “EQ” and then 

press 

n

Cursor

l

 / 

h

.

If this unit does not work when you press 

n

Cursor

, 

press 

l

SETUP

 once and then operate this unit.

This unit has a parametric equalizer that adjusts the 
output levels for each frequency range. The equalizer 
is adjusted to produce a cohesive sound field based on 
automatically measured speaker characteristics. 
In “EQ,” you can select the following parametric 
equalizer characteristics suitable for the desired 
sound characteristics.

Natural

This adjusts all speakers to achieve natural sound. 
Select this if sounds in the high frequency range seem 
too strong when “EQ” is set to “Flat.”

Flat

This adjusts each speaker to obtain the same 
characteristics. Select this if your speakers have 
similar qualities.

Front

This adjusts each speaker to obtain the same 
characteristics as the front left and right speakers. 
Select this if your front left and right speakers have 
significantly better qualities than the other speakers.

5

Press 

n

Cursor

n

 to select “Start” and then 

press 

n

ENTER

 to start the setup procedure.

A countdown starts and a measurement starts in 10 
seconds. A loud test tone is output during 
measurement.

Notes

•

During the automatic setup procedure, do not perform any 
operation on this unit.

•

Press 

n

Cursor

k

 to cancel the automatic setup procedure.

When measurement is successfully completed, 
“YPAO Complete” appears on the front panel display.

Notes

•

When “E-xx” (xx indicates the number) appears during Auto 
Setup, it means that measurement is canceled due to an error. For 
details, see “When an error message is displayed during 
measurement” (page 20).

•

When an error occurs during measurement, “W-xx” (xx indicates 
the number) appears. For details, see “When a warning message is 
displayed after measurement” (page 20).

6

Press 

n

ENTER

 to confirm the settings.

The speaker characteristics are adjusted according to 
measurement results.

7

To cancel the operation, press 

n

Cursor

l

 / 

h

 to select “Cancel” and press 

n

ENTER

.

When “Disconnect MIC” appears, remove the 
optimizer microphone. Auto Setup is complete.

y

•

If you do not want to apply the measurement results, select “Cancel.”

•

Perform “Auto Setup” again if you change the number or positions of 
speakers.

•

If you press 

n

ENTER

 before removing the optimizer microphone, 

“1 Auto Setup” of “Speaker Setup” in the setup menu (see page 41) is 
displayed.

Measurement takes about 3 minutes. To obtain precise 
results, stay where you will not disturb the 
measurement, such as to the side of or behind the 
speakers or outside the room.

E Q

;;;;;

N a t u r a l

Y P A O  C o m p l e t e

The optimizer microphone is sensitive to heat. Store it 
in a cool place and away from direct sunlight after 
measurement. Do not leave it in a place where it will be 
subjected to high temperatures such on an AV 
component.

 > S e t   C a n c e l