Триммеры Ryobi RBC430SBSD 5133002548 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
30
English (original instructions)
EN
FR
DE
ES
IT
PT
NL
SV
DA
NO
FI
HU
CS
RU
RO
PL
SL
HR
ET
LT
LV
SK
BG
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Engine will not start
1. No spark.
1. Clean or replace spark plug. Reset spark plug gap.
Refer to Spark Plug Replacement earlier in this manual.
2. No fuel.
2. Push primer bulb until bulb is full of fuel. If bulb does not fill, primary
fuel delivery system is blocked. Contact a service dealer.
If primer bulb fills, engine may be flooded, proceed to next item.
3. Engine is flooded.
3. Set the start lever to the START position. Squeeze the trigger
and pull the rope repeatedly until the engine starts and runs.
NOTE:
Depending on the severity of the flooding, this may
require numerous pulls of the rope.
Engine does not reach full
Fuel flow problem
Squeeze and release the throttle trigger 5 times while the engine is
speed
running.
Engine does not reach full
1. Air filter screen is dirty.
1. Clean air filter screen.
speed and emits excessive
2. Spark arrestor screen is dirty.
Refer to Cleaning Air Filter Screen earlier in this manual.
smoke
2. Contact a servicing dealer.
3. Spark plug fouled.
3. Clean or replace spark plug. Reset spark plug gap. Refer to Spark
Plug Replacement earlier in this manual.
Engine starts, runs, and
Idle speed screw on carburettor
Turn idle speed screw clockwise to increase idle speed.
but will not idle
needs adjustment.
See Figure 15.
String will not advance
1. String is welded to itself.
1. Lubricate string with silicone spray.
2. Not enough string on spool.
2. Install more string. Refer to the applicable string replacement
section in this manual.
3. String is worn too short.
3. Pull strings while alternately pressing down on and releasing
spool
retainer.
4. String is tangled on spool.
4. Remove string from spool and rewind.
Refer to the applicable string replacement section in this manual.
5. Engine speed is too slow.
5. Advance string at full throttle.
Spool retainer hard to turn
Screw threads are dirty or
Clean threads and lubricate with grease - if no improvement,
damaged.
replace the spool retainer.
Grass wraps around
1. Cutting tall grass at ground
1. Cut tall grass from the top down to prevent wrapping.
driveshaft housing and
level.
string head
2. Operating trimmer at part
2. Operate trimmer at full throttle.
throttle.
Engine emits too much
Too much oil in crankcase.
Drain lubricant and refill with correct amount of 10W-30 engine
smoke
lubricant. See
Adding/Checking Engine Lubricant
in the
Operation section of this manual.
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORISED SERVICE DEALER.
CALL US FIRST
For any questions about operating or maintaining your product, call the Ryobi
®
Help Line!
Your product has been fully tested prior to shipment to ensure your complete satisfaction.
