Makita EBH341R - Инструкция по эксплуатации - Страница 15

15

POINTS IN OPERATION AND HOW TO STOP

Observe all applicable accident prevention regulations!

STARTING

Move at least 3m away from the place of refuelling.  Place the brush cutter on a clean piece of ground taking care that the cutting tool does
not come into contact with the ground or any other objects.

A:Cold start

1) Set this machine on a flat space.

2) Set the I-O switch (1) to OPERATION.

3) Choke lever

Close the choke lever.

Choke opening:

– Full closing in cold or when the engine is cold.

– Full or half opening in restart just after stop of operation.

4) Primer pump

Continue to push the primer pump until fuel enters into the primer pump. (In
general, fuel enters into the primer pump by 7 to 10 pushes.)

If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.

5) Recoil starter

– Pull the start knob gently until it is hard to pull (compression point). Then,

return the start knob, and pull it strongly.

– Never pull the rope to the full. Once the start knob is pulled, never

release your hand immediately. Hold the start knob until it returns to its
original point.

6) Choke lever

When the engine starts, open the choke lever.

– Open the choke lever progressively while checking the engine operation.

Be sure to open the choke lever to the full in the end.

– In cold or when the engine is cooled down, never open the choke lever

suddenly. Otherwise, the engine may stop.

7) Warm-up operation

Continue warm-up operation for 2 to 3 minutes.

I-O switch (1)

Lock-off lever

Throttle lever(6)

OPERATION

Caburettor

Primer Pump