Yamaha DV-C6860 - Инструкция по эксплуатации - Страница 37

33 

En

English

Troubleshooting

No audio at digital output

– Check the digital connections.
– If you are playing a DTS source, check that your receiver can 

decode DTS and “DIGITAL OUTPUT” is set to “ALL” (see 
page 23).

– If you are playing an MPEG-2 source, check that your 

receiver can decode MPEG-2. Otherwise, make sure 
“DIGITAL OUTPUT” is set to “PCM ONLY” (see page 23).

– Check if the audio format of the selected audio language 

matches your receiver capabilities.

Disc does not play

– The DVD+R/RW, DVD-R/RW, CD-R/RW must be 

finalized.

– Ensure the disc label is facing up.
– Check if the disc is defective by trying another disc.
– If you have recorded a picture CD or MP3 CD yourself, 

ensure that your disc contains at least 10 pictures or 5 MP3 
tracks.

– Region code is incorrect (see “Region codes” on page 2).

Picture freezes momentarily 
during playback

– Check the disc for fingerprints/scratches and clean it with a 

soft cloth wiping from center to edge.

This unit does not respond to 
the remote control

– Aim the remote control directly at the remote control 

sensor on the front panel of this unit.

– Reduce the distance of the remote control from this unit.
– Replace the batteries in the remote control.
– Reinsert the batteries with their polarities (

+

/

–

 signs) as 

indicated.

Buttons do not work

– To completely reset this unit, unplug the AC cord from the 

AC outlet for 5-10 seconds.

This unit does not respond to 
some operating commands 
during playback

– Operations may not be permitted by the disc. Refer to the 

instructions of the disc jacket.

This unit cannot read CDs/
DVDs 

– Use a commonly available CD/DVD lens cleaner to clean 

the lens before sending this unit for repair.

Menu items cannot be selected

– Press STOP (

9

) twice on the remote control before 

selecting Setup Menu.

– Depending on the disc availability, some menu items cannot 

be selected.

Unable to turn on or off a 
progressive scan

– Check that the video signal output is switch to “YUV” (see 

“Switching the YUV/RGB” on page 27).

Problem

Solution