Gardena ErgoJet 3000 - Инструкция по эксплуатации - Страница 26

 WARNING:

 If the unit becomes clogged, stop the unit and unplug the 

extension cord. Wait until the impeller has completely stopped turning, 
then remove the vacuum tubes. Carefully reach into the vacuum opening 
and clear out the clogged debris. 
This will reduce possible personal injury from the impeller.

Removing an object from the 
air intake:

1. Remove the vacuum tubes.

2.  Carefully reach into the vacuum opening and clear out the air 

intake area. Clear all debris from impeller.

3.  Inspect the impeller for cracks. If cracked or damaged, 

do not use the unit. Have parts replaced by your authorized 
 service dealer. Do not attempt to replace them yourself.

7. Troubleshooting

WARNING:

 Always stop unit and unplug the extension cord before 

performing all of the recommended remedies below except remedies 
that require unit to be operating. 
The motor must be stopped and the impeller blades no longer turning to 
avoid serious injury from the rotating blades.

Problem 

Possible cause

Remedy

Unit fails to operate.

1. Switch in the OFF (0) position.

1.  Slide switch to 

ON (I) position.

2. Extension cord disconnected.

2. Reconnect extension cord.

3.  Circuit breaker tripped, 

or fuse blown.

3.  Reset circuit breaker or 

fuse.

4.  Blower tube, elbow tube, 

and/or vacuum tube not 
installed correctly.

4.Check tube installation.

5. Collection bag is full.

5. Empty collection bag.

6. Mechanical failure.

6.  Contact your authorized 

 service d ealer.

Unit vibrates abnormally.

1. Mechanical failure.

1.  Contact your authorized 

 service d ealer.

Impeller will not 
turn freely.

1. Debris in air intake area.

1.  Clean unit. Remove any 

debris.

2. Mechanical failure.

2.  Contact your authorized 

service dealer.

 For any other malfunctions, please contact the GARDENA 
service department. Repairs must be carried out by GARDENA 
service departments or specialist dealers authorised by 
GARDENA.

26

GB

9332-20.960.01.indd   26

04.01.12   07:47