Siemens TE80620RW - Инструкция по эксплуатации - Страница 24

20

en

Add 0.5 l water and descaler 



start

●

Pour lukewarm water into the empty 
water tank 

11

 up to the “

0.5 l

” mark and 

then dissolve two Siemens descaling 

tablets in it.

●

Press the 

start

 button 

8

. The  descaling 

programme will now run for about 

20 minutes.

Descaling

Not enough descaling fluid.  
Refill fluid 



start

Info: 

If there is not enough descaling solu

-

tion in the water tank 

11

, the corresponding 

prompt is displayed. Pour in descaling solu-

tion and press the 

start

 button 

8

 again.

Clean and refill water tank  



start

●

Rinse the water tank 

11

 and reill it with 

fresh water up to the “

max

” mark.

●

Press the 

start

 button 

8

. The descaling 

programme now runs for about 1 minute 

and rinses the appliance.

Descaling

Empt y drip tray

Repl ace drip tray

● Empty the drip tray 

23

 and reinsert it.

Replace the ilter if one is being used. The 

appliance is ready for use again.

Important:

 Wipe down the appliance using 

a soft, damp cloth to immediately remove 

any descaler residue. Such residue can 

cause corrosion. New sponge cloths may 

contain salts. Salts can cause rust ilm 

on stainless steel and must therefore be 

washed out thoroughly before use.

Thoroughly clean the suction pipe 

10d

 of 

the milk frother.

Cleaning

Duration: approx. 8 minutes. 

Cle aning and serv ice 

Desc ale 
Cle an 



s tart

The 

start

 button 

8

 lashes while the differ-

ent cleaning processes are running. The 

igures on the top right indicate the progress 

of the programme.

●

Fill the water tank 

11

 up to the “

max

” 

mark.

●

Press the 

à

 button 

3

.

Clean 



start

●

Press the 

start

 button 

8

; the display 

5

 will 

guide you through the programme.

Empt y drip tray  
Repl ace drip tray

● Empty the drip tray 

23 

and reinsert it. The 

appliance rinses twice.

Position swivel arm

●

Swivel the coffee outlet 

9

 to the 

left

 until it 

clicks into place.

Cleaning

Open powder compartment

●

Open the powder compartment 

18

.

Insert Siemens cleaning tablet 
and close drawer

●

Drop a Siemens cleaning tablet into the 
drawer 

18

 and close it.

Press start

●

Press the 

start

 button 

8

. The clean-

ing programme will now run for about 

7 minutes.

Cleaning 

TE803_806_1RW.indb   20

08.05.2013   14:24:14