Siemens TE80620RW - Инструкция по эксплуатации - Страница 17

13

en

 Water  filter

A new water i lter must be rinsed before it 

can be used. 

● To do this, press the water i lter i rmly 

into the water tank 

11

 with the aid of the 

measuring spoon 

14

. Fill the water tank 

with water up to the “

max

” mark. 

●

Turn the rotary knob 

6

 to select 

start

and press the 

start

 button 

8

.

Pl ace 1 l container
Pl ace suction pipe in container 



start

● Place a container with a capacity of 1 litre 

under the milk frother 

10

.

●

Place the end of the suction pipe 

10d

 in 

the container.

●

Press the 

start

 button 

8

. Water will now 

l ow through the i lter to rinse it.

● Next, empty the container. 

The appliance is ready for use again. 

Info: 

Rinsing the i lter simultaneously 

activates the setting for the “change i lter” 

display. 

You can i nd detailed information about the 

water i lter in the enclosed i lter instructions.

The i lter is no longer effective when the 

Service - change filter

 display appears, 

or at the latest after two months. It needs to 

be replaced for reasons of hygiene and so 

that there is no build-up of limescale (this 

could damage the appliance).

Replacement i lters can be obtained from 

retailers (TZ70003) or from customer 

 service (575491).

If no new i lter is used, turn the 

Water 

 filter

 setting to 

no

.

Info: 

If the appliance has not been used for 

a prolonged period (for example, when you 

are on vacation), the existing i lter should 

be rinsed before the appliance is used 

again. To do this, simply dispense a cup of 

hot water.

 Transport.  lock 

●

To avoid damage caused by frost during 
transport and storage, the appliance must 

be completely emptied i rst.

Info: 

The appliance must be ready for use 

and the water tank 

11

 i lled.

●

Press the 

start

 button 

8

. The appliance 

automatically empties the pipe system 

and switches off.

● Empty the water tank 

11

 and the drip 

tray 

23

.

 Factory  reset

You can cancel your own settings and reset 

the factory settings.

●

To activate the factory settings, press the 

start

 button 

8

.

Info:

 The appliance can also be reset to 

the factory settings using a combination of 

buttons. The appliance must be switched 

off fully.

●

Hold down the selection buttons 

<

 and 

>

4

 and the on/off switch 

1  O / I

 at the 

same time for at least 5 seconds. Press 

the 

start

 button 

8

. The factory settings 

are now reactivated.

TE803_806_1RW.indb   13

08.05.2013   14:24:10