Bosch TES 50221 RW - Инструкция по эксплуатации - Страница 11

7

TES502 | 02/2013

7

en

Note:

 You can use the fi lter indicator to 

mark the month in which you inserted the 

fi lter. You can also mark the month in which 

you will need to replace the fi lter next (at 

the latest after two months).

Note: 

If the appliance has not been used 

for a prolonged period (e.g. vacation) the 

fi lter should be rinsed before the appliance 

is used again. To do so, dispense a cup of 

hot water and pour it away.

 Menu settings

You can adapt the appliance to your indi-

vidual needs in the menu settings. 

1.  Hold the 

e

off

/

j

 button (12) down for 

at least 3 seconds.

2.  Press the 

e

off

/

j

 button (12) repeat-

edly until the required menu item 

appears in the display. 

3.  Select the required setting with the 

upper rotary knob (14). 

4.  Confi rm by pressing the 

start

 button 

(10). 

To leave the menu without making any 

changes, turn the rotary selector to 

Exit

and press the 

start

 button (10). 

You can set the following:

 Shut off

Here you can set the time span after which 

the appliance automatically switches off 

following the last drink preparation. A time 

between 15 minutes and 4 hours can be 

set. The default time is 1 hour, but this can 

be shortened to save energy.

Filter

Here you can set whether a water fi lter is 

being used. If a water fi lter is not being 

used, turn the setting to 

No / Old

. If a 

water fi lter is being used, turn the setting to 

Activate fi lter

. New water fi lters have to 

be rinsed before use (see “Water fi lter” on 

page 6).

 Start Calc‘n‘Clean

The service programmes (

Calc‘n‘Clean

 / 

descaling

 / 

cleaning

) can be selected 

manually here. Press the 

start

 button (10) 

and run the selected programme (see 

“Service Programmes” on page 13).

 Temp.

The brewing temperature (

high

 / 

middle

 / 

low

) can be set here.

 Language

The display language can be set here.

 Water hardness

The water hardness setting can be adjusted 

on this appliance. It is important to set the 

water hardness  correctly, so that the appli-

ance indicates accurately when the descal-

ing programme should be run. The factory 

setting for the water hardness is 4. 

You can check the water hardness using 

the enclosed test strip or by asking your 

local water supplier. 

Dip the test strip briefl y in water, gently 

shake off any drips, and check the result 

after one minute.

Level Water hardness

German (°dH)

French (°fH)

1

2

3

4

1-7

8-14

15-21

22-30

1-13

14-25

26-38

39-54

TES502_1RW.indb   7

21.02.2013   13:38:17