AL-KO 2000 i - Инструкция по эксплуатации - Страница 24

GB

Original instructions for use

24

Petrol Generator INVERTER 2000i

(green) (  

15/3) 

is not lit anymore. Power generation is 

interrupted, the engine continues running.
1.  Switch off all connected electric devices.
2.  Switch off the engine
3.  Reduce the total power of the connected electric 

devices within the rated output power

4.  Check ventilation grille and operating panel for 

contamination and clean if necessary

5.  Restart the engine after the check

If electric devices requiring a high starting current 

(such as a compressor or submersible pump) are 

used, the overload indicator lamp can light up for 

a few seconds. However, this is not a malfunc-

tion.

AC indicator lamp (green) 

(  

15/3

)

The AC indicator lamp lights up if the engine is running 

and power is generated.

DC safety switch 

(  

16

)

The DC safety switch switches automatically to “OFF”  

(  

16/2

), if electric consumers are connected to the 

generator and the electrical power is greater than the 

operating current. 

Switch on the DC safety switch again by pressing the 

“ON” button (  

16/1

) in order to use the machine again.

Important!

If the DC safety switch switches to "OFF", reduce 

the total power of all connected consumers to 

the maximum rated power (DC) of the generator. 

Please contact the AL-KO service centre if the 

DC safety switch permanently switches to "OFF".

ESC (Engine Smart Control) 

(  

8

)

“ON”

If the ESC switch is switched to “ON”, the Economy  

control unit controls the engine speed depending on the 

power of the connected electric devices. This results in 

lower fuel consumption and less noise. 

“OFF”

If the ESC switch is switched to “OFF”, the engine runs at 

nominal speed (5000 rpm) regardless of any connected 

electric devices.

The ESC switch must be set to "OFF" if electric 

devices with high starting current (such as a com-

pressor or submersible pump) are connected.

Connecting power consumers to AC

Important!

The total power of all connected consumers must 

not exceed the maximum rated power of the 

generator

1.  Check whether the AC indicator lamp is lit
2.  Plug consumer into the socket of the generator 

If several consumers are connected to the gen-

erator, connect and switch on the first consumer 

(consumer with highest power) first. Then con

-

nect and switch on further consumers.

Disconnecting power consumers

1.  Disconnect consumer from the socket of the 

generator

Connecting a 12-Volt (car) battery for charging

Important – Danger of explosion!

Do not mix up the charging cables during battery 

connection

Important 

Observe the information of the battery manufac-

turer regarding battery charging

2.  Start the engine
3.  Connect the battery charging cable to the DC 

connection (12 V)

4.  Connect the red charging cable with the positive 

battery terminal

5.  Connect the black charging cable with the negative 

battery terminal

6.  Switch the ESC switch to “OFF” to start charging

Switching the engine off

Only switch the generator off, after it has been 

running for 30 seconds without any load (without 

consumers connected)