Yamaha RX-V463 - Инструкция по эксплуатации - Страница 78

76

 En

Troubleshooting

After AUTO SETUP

• If the “ERROR” or “WARNING” screens appears, check the cause of the problem, then run “AUTO SETUP” again.
• If a warning message “W-1”, “W-2”, or “W-3” appears, corrections are made, but they may not be optimal.
• If an error message “E-9” occurs repeatedly, please contact a qualified Yamaha service center.

Warning message

Cause

Remedy

See 

page

W-1:OUT OF PHASE

Speaker polarity is not correct. This 
message may appear depending on the 
speakers even when the speakers are 
connected correctly.

Check the speaker connections for proper 
polarity (+ or –).

12

W-2:OVER 24m (80ft)

The distance between the nearest speaker 
and the furthest speaker is out of adjustable 
range.

Bring the speaker closer to the listening 
position.

—

W-3:LEVEL ERROR

The difference of volume level among 
speakers is excessive. (No level correction 
is made.)

If “SWFR:TOO LOUD” or “SWFR:TOO 
LOW” appears, adjust the output volume of 
the subwoofer.

24, 59

Readjust the speaker installation so that all 
speakers are set in locations with similar 
conditions.

—

Check the speaker connections.

11

Use speakers of similar quality.

—

Notes