Yamaha RX-V463 - Инструкция по эксплуатации - Страница 56

RECORDING

54

 En

Recording adjustments and other operations are performed from the recording components. Refer to the operating 
instructions for those components.

• When this unit is set to the standby mode, you cannot record between other components connected to this unit.
• TONE CONTROL (see page 41) and VOLUME settings, speaker levels (see page 41) and the sound field programs (see page 38) do 

not affect recorded material.

• The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.
• Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Therefore, if 

your source component is connected to provide only digital signals, you cannot record the source.

• A given input source is not output on the same AUDIO OUT (REC) channel.
• The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.
• Once you have connected a recording component to this unit, keep the component turned on while using this unit. If the component is 

turned off, this unit may distort the sound from other components.

• Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright 

laws.

y

Do a test recording before you start an actual recording.

1

Turn on all the connected components.

2

Press 

O

INPUT

l

 / 

h

 repeatedly (or press 

one of the input selector buttons (

3

)) to 

select the source component you want to 
record from.

3

Start playback on the selected source 
component or select a broadcast station.

4

Start recording on the recording component.

Recording

Notes

If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture 
itself may be disturbed due to those signals.